How do I reset my Concord 4?
How do I reset my Concord 4?
The light on the smoke detector remains lit until it is reset. Press 1, code again to reset hardwired detectors and clear alarm memory. Note: In some cases, your installer may have installed a smoke detector reset switch. If so, press and hold the switch for at least 1 second, then release it to reset smoke detectors.
How do I turn off the trouble beep on my Concord 4?
Press the * (STATUS) button or arm/disarm the system to silence the beeps. They will resume after four hours unless the problem has been corrected.
How do you program on Concord 4?
To enter program mode: Press 8, 4321, 0, 0. The display shows SYSTEM PROGRAMMING.
How do I reset my Concord Express?
Concord – If Master Code is Lost
- Press 9 then enter the Installer Code 4321 to display SYSTEM MENU then TIME-DATE.
- Press 3, SHORTCUT 03 appears, press # for USER CODES then # for REG CODES.
- Press A or B button until SYS MASTER displays then press #
- Master Code displays, to change enter new Master Code then press # to save.
How do you program a Concord 4?
To enter program mode: Press 8, 4321, 0, 0. The display shows SYSTEM PROGRAMMING. To enter program mode using a programming touchpad: 1.
How do I clear the alarm memory on Concord?
To begin this process, press the “asterisk” key. While the keypad begins displaying status updates, press the “disarm” button followed by your 4-digit alarm code. This will clear the system memory and prevent the system from displaying the same message again for 4-10 hours.
How do you do the phone test on Concord 4?
To run a cellular comm test on an GE Interlogix Concord 4 hybrid system Press 8 + Installer Code (default 4321) + 2, then disarm the system immediately, This procedure will initiate the comm test on your Concord 4.
How do I program on Concord?
Press 8 + 4321 + 0 + 0. The display shows “SYSTEM PROGRAMMING”.
Why does the Concord 4 send test signals every hour?
A variety of issues may be at fault for disturbing your peace. Unlike some of its predecessors, the Concord 4 sends test signals to check on communication between the panel and sensors every hour. It also has the capability to send test signals to the central station.
What does it mean when your Concord security system says Trouble?
One of the most common security system trouble conditions occurs when the system’s backup battery (shown inside a Concord 4 panel) requires changing. Many trouble messages stay in place after you read them. This usually indicates an ongoing issue and not simply an “old” status.
What is the “asterisk key” on the Concord 4 alarm panel?
On the Concord 4 Alarm panel, your “asterisk key” acts as the status indicator key. A variety of issues may be at fault for disturbing your peace. Unlike some of its predecessors, the Concord 4 sends test signals to check on communication between the panel and sensors every hour.
What can I do if my system is saying sensor open?
My system is saying “Sensor open”. What can I do? If your door or window is closed but the keypad is reporting it open, this means your sensor is out of alignment. This can also mean your sensor or magnet has fallen off the door or frame. 1. Go to your keypad to identify the zone showing open 2. Verify the sensor and magnet are both on the door 3.
https://www.youtube.com/watch?v=PmRFU7aZulY
