Useful tips

What is the default IP address of NanoStation M5?

author 0

What is the default IP address of NanoStation M5?

192.168.1.20
On the original Nanostation shipping box, find and write down the default IP address (we assume: 192.168. 1.20), the user name and password (should both be “ubnt”).

How do I reset my ubiquiti access point?

Physical Reset

  1. Press and hold the reset button for 10 seconds while AP is connected.
  2. Release the button (the LEDs on the UAP will stop glowing).
  3. Do not disconnect the UAP from its power source during the reboot process.
  4. The UAP will restore factory settings.

How do I reset my tp link Deco M5?

How to factory reset (hard reset) TP-LINK Deco M5 :

  1. Open a browser and navigate to the web interface of the router (see default settings below)
  2. In the menu look for System tools and under there find the Factory defaults option.
  3. On the Factory defaults page click on the Restore button to perform the reset.

How do I Reset my Nanostation m2/m3/m5?

Secondary (NanoStationM2/M3/M5 only) 10/100 Ethernet port used for bridging and supports software-configurable PoE passthrough. Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the NanoStation is already powered on.

Where is the remote reset button on the nanostationlocom2/m5?

Alternatively, a remote reset button is located on the bottom of the PoE Adapter. Switching Gigabit Power Supply / PoE RESET Reset Button * Main is labeled LAN on the NanoStationlocoM2/M5. fHardware Installation 1. Press the Port Cover Release Button located on the back of the NanoStation and slide the cover off.

How do I Reset my unifi device to factory default settings?

UniFi devices can also be reset to factory defaults using physical reset button. The location of the reset button will differ depending on the UniFi model that you are using. The Quick Start Guide (QSG) for each model displays the location of the reset button and provides more information on the reset process.

How do I Reset my Device to factory defaults?

Make sure your cables are good. If there’s a small voltage on the data pair of your cable, the device will reset itself to factory defaults (that’s how the reset switch on the Ubiquiti PoE injector works). You can disable this feature in the GUI as well.

author

Back to Top