Why does my dryer keep saying check lint screen?
Why does my dryer keep saying check lint screen?
The control panel has an indicator light “Check Lint” or “Check Lint Screen” to remind you to clean the lint screen before each load. It is normal for the light to be on or flashing before the cycle starts. The indicator light will turn off once the door is opened or a cycle is started.
How do you clean the lint filter on a Bosch Nexxt dryer?
To clean your dryer’s exterior, simply wipe it down with a damp cloth. To clean the lint filter, pull out the filter and remove the lint. Wash the filter gently under running water to remove any additional lint and allow it to completely dry. Reinsert the filter into the dryer.
How do you clean a lint filter?
Pull out your lint trap and remove all of the excess lint with your hand or a vacuum cleaner hose attachment. Place the lint trap into the hot water and allow it to soak for 10 minutes. Use a sponge, rag, or nylon brush to remove the loosened residue. Rinse completely with clean water.
Where is the sensor on a Bosch dryer?
It’s located behind the dryer drum or behind a separate panel in the back of the dryer. Over time, it can wear out and you’ll notice your Bosch dryer not heating appropriately.
Why is my Bosch tumble dryer not heating up?
There are multiple reasons why a dryer stops heating up: heating element might need to be replaced, a faulty thermal fuse, or a defective timer motor. It’s important to note that only a Bosch expert can help you successfully determine the source of this issue with your dryer.
How do I clean the lint out of my front load dryer?
Instructions
- Remove lint screen from the dryer and wash in warm soapy water (see notes below)
- Use a screwdriver to remove the “cover” from the lint filter compartment and thoroughly clean with vacuum and microfiber cloth.
- Use a lint vent cleaning brush to loosen lint and debris inside the dryer.
