Are there different size strike plates?
Are there different size strike plates?
We stock 6 different widths and 6 finishes. Strike plate width is measured from center of screw holes to leading edge of strike plate.
What is the standard size of a door strike plate?
A ANSI strike plate reinforces locks and deters tampering or kick-ins. Includes metal and wood screws. Size 4-7/8″ x 1-1/4″ in. …
What is a box strike plate?
A box strike gives the lock a far stronger hold on the door, and the 2-inch screws anchor it to the door frame.
What is the thing called that the door latch goes into?
The latch bore, also known as the edge bore, is the hole drilled from the side of the door into the cross bore to allow the latch of the lock to be installed and to accommodate the sliding of the deadbolt. The diameter of the latch bore is generally 1” to accommodate bolts from either mechanical or electronic locksets.
What is full lip strike?
Full Lip Strike: The full lip strike is the most common. As you can see there are 2 different kinds of full lip strikes: round corner or square. The measurement that this strike plate is showing would be considered the width, because it would be the width if it was on the door jamb.
How do you measure a latch strike plate?
Measure from the edge of the door to the center of the latch bolt. (With the door opening toward you, you’ll measure from the edge furthest away from you.) On the strike plate, measure from the flat edge to the center of the strike plate. The difference tells you how far to move the strike plate left or right.
Do deadbolts come with strike plate?
This 2-piece high security deadbolt strike replaces standard exterior residential deadbolt strikes adding increased security to entry doors. This item includes one 2-piece strike plate per package with fasteners.
How important is strike plate?
Strike plates take on an even more significant role when using deadbolts to protect your home from thieves. When installed properly, this element helps protect the door frame and lock from being opened from someone trying to push it open from the outside.
What is the hole for a deadbolt called?
latch bore
The latch bore, also known as the edge bore, is the hole drilled from the side of the door into the cross bore to allow the latch of the lock to be installed and to accommodate the sliding of the deadbolt. The diameter of the latch bore is generally 1” to accommodate bolts from either mechanical or electronic locksets.
What is the metal plate on a door called?
Strike Plate. A strike plate is the metal piece attached to the door jamb. As the door closes, the latch mechanism strikes the plate mounted to the jamb and the strike plate catches the mechanism and holds the door closed.
What is an ASA strike?
The term “ASA” is still used by some commercial door manufacturers as follows: ASA: The designation for the 4 7/8˝ high strike with lip (per ANSI A115. 2) with the centerline of the strike located @ 40 5/16” above the bottom of the frame.
What size is a deadbolt hole?
2 1/8-inch
Be sure to use the correct size drill bits specified in the lock set instructions, though most standard deadbolts require a 2 1/8-inch hole saw for the lock bodies and a 1-inch spade bit for the sliding bolt assembly.
https://www.youtube.com/watch?v=owGDWMsrNcM
