How do you break-in a new Harley Davidson engine?
How do you break-in a new Harley Davidson engine?
Break-In Riding Procedure
- During the first 50 miles of riding, keep the engine speed below 3,000 RPM (5,000 RPM for VRSC™) in any gear.
- Up to 500 miles, vary the engine speed and avoid operating at any speed for long periods.
- Drive slowly and avoid fast starts at wide-open throttle until the engine has warmed up.
How long does it take to break-in a Harley engine?
Harley-Davidson recommends a conservative break-in process for its engines over the first 500 miles of their operation. The manufacturer suggests that engines not be run faster than 3,000 rpm during the first 50 miles of operation, with no running at extremely high or low rpm for extended periods.
Do you really need to break-in a new motorcycle?
Your owner’s manual likely recommends a 600-, 1,000-, or even a 1,500-mile break-in process where you limit throttle angle and revs, and constantly vary engine speed so that all those new internal components can get to know each other. For a new-bike owner, it’s a slow, grueling march toward your first service.
How important is the break-in period for a new motorcycle?
A new motorcycle’s breaking-in period lasts for about the first 500 – 1000 miles on the road. Manufacturers believe that a properly broken-in motorcycle will have lower emissions and better fuel economy, performance, and engine longevity. In addition, other key components will also work better and longer.
What RPM should I shift on a Harley?
While most bikes are happy shifting at 5,000 to 7,000 RPMs, it is best to judge by the sound and feel of the engine. As you move faster, its pitch will increase. When the pitch is high, it is time to shift. If you shift too soon, you will hear the engine struggle, which will help you learn the correct shift points.
How important is motorcycle break-in?
Do you need to break in a new engine?
Do You Need to Break in a New Car? Most manufacturers recommend breaking in new cars, and you can find this information in your vehicle’s manual. Breaking in an engine ensures that early engine wear is kept to a minimum, and that the oil flows smoothly and evenly through all moving parts.
How do you break in a new bike?
For the first 500 to 1,000 miles, avoid using more than ¾ throttle. Always avert high engine speeds. Do not make hard stops, aggressive starts, or rapid acceleration unless there is an emergency. While breaking in your motorcycle, increase your bike’s engine speed to the rev limit for short time periods.
Do new engines need to be broken in?
What happens if you don’t break in a new Harley-Davidson motorcycle engine properly?
A new Harley-Davidson motorcycle begs to be ridden, but simply jumping on a new bike and riding without a plan for properly breaking in the new engine can lead to long-term mechanical problems. An engine that is not correctly broken in can be subject to premature component failure, excessive oil consumption and inadequate power production.
Who is responsible for break-in for a new motorcycle engine?
Harley-Davidson provides guidance for optimal break-in procedures, and its dealers get the process started, but the bulk of the responsibility for a new engine’s break-in lies with the bike’s owner.
What is engine break-in?
Breaking in a new engine is a critical process that ensures that the engine will operate efficiently over its entire lifetime and that vital engine components will last as long as they should.
How fast should a Harley-Davidson motorcycle engine run?
Between 50 and 500 miles, Harley-Davidson recommends running the engine at varying speeds and avoiding prolonged operation at any one speed; engine rpm up to 3,500 are acceptable during this period.
