What is NM 1FE TX?

What is NM 1FE TX?

NM-1FE-TX. Product Name. Fast Ethernet Network Module. Marketing Information. The 1-port Fast Ethernet network module offers a single auto-sensing 10/100TX connection via an RJ-45 connector.

What are the names of two different modules in Cisco?

Midsize Business

• Cable access.
• Converged SDN transport.
• Network automation.
• Optical networking.
• Optics and transceivers.
• Services orchestration.
• Telco cloud.

What is SM slot in router?

Service Module Slots are used for router modules that run specific services that could be either Cisco proprietory or third party applications. These modules have their own processors, memory etc and don’t use any of the router’s resources.

What is service module in router?

Router1# show ip interface brief. The service-module gigabitethernet 0/x/0 session command is the privileged EXEC mode command used to console into the switch module from the host router. You need to console into the switch module to configure it.

What is WIC 1T?

The WIC-1T features the Cisco 5-in-1 connector which supports several serial protocols (V. 35, X. This facilitates easy configuration and re-configuration as network requirements change without the need to purchase a different serial interface card.

How many ports does a Cisco switch have?

Usually, there are 12 ports PoE Switch in Cisco Compact switch family.

What is module in network?

A network module is a software module that implements a specific function in a network stack, such as a data link interface, a transport protocol, or a network application. A network module can be a provider module, a client module, or both, depending on where it is located in the network stack.

How many modules are there in CCNA?

The CCNA Routing and Switching programme can be completed as four separate modules. You will find details of each module below.

What is WIC-2T?

Overview. WIC-2T Cisco 2-Port Serial Wan Interface Card. The dual serial port WIC-2T provides higher levels of serial port density than a single WAN interface card and is supported on the Cisco 2600 series and supports speeds of up to 2.048Mbps.

What are the different form factors available for Cisco network modules?

Cisco network modules are available in the following five form factors to provide greater modularity and functionality for users: Single-wide network module with a network module adapter for use in Cisco 2900 series and 3900 series ISRs.

How many nm-36esw network modules can be installed per chassis?

Only one NM-36ESW network module can be installed per chassis. Only two extension modules can be installed per chassis. Tip To install double-wide or extended double-wide network modules, remove the slot divider. (See the “Removing Slot Dividers” .). Only two NM-36ESW network modules can be installed per chassis.

Are extended double-wide network modules supported on the Cisco 2851?

Extended double-wide network modules are supported only on the Cisco 2851 and Cisco 3800 series routers. Extended double-wide network modules occupy two extended single-wide network module slots, which must be set up properly before extended double-wide network modules can be installed.

How are single-wide network modules installed in Cisco ISRS?

Single-wide network modules are installed in Cisco 2900 series and 3900 series ISRs by using a network module adapter. Figure 1 Sample Single-Wide Network Module Extended single-wide network modules are installed in configurable network module slots on the Cisco 2821, Cisco 2851, and Cisco 3800 series routers.