How do captive bead earrings work?
How do captive bead earrings work?
The captive bead or ball fits into a small opening in the circle of the ring. The bead is slightly larger than this opening and has small indentations or depressions that correspond to the ring’s end-points so that it may fit snugly against them, thus completing the circuit of the ring.
How do you open a captive hoop?
Hold the ring steady with your free hand and push the captive bead into the open segment of the ring. The captive bead should pop into place. If the open segment is too narrow, you can use the ring opening pliers to expand it slightly.
How do you attach a BCR captive ring?
Insert one open end into your piercing. Glide the wire of the ring into the piercing until the center of your ring rests inside. The opening of the ring should lie directly across from the piercing itself. You may need to use your fingers to support the skin around the piercing as you slide the jewelry in place.
How do you put a small captive bead ring on?
Use your hands to push the bead back into the ring, stopping once it clicks into place. You’ll need to steady the ring by holding one side of it with the index finger and thumb of one hand. Use the other hand to push the ball back into place. If properly inserted, the ball should spin with a little resistance.
How do captive rings work?
Tension-Style Captive Rings When you push the ball into the ring, the pieces retract to allow the ball to fit in place. Once the ball’s been snapped in, the hidden springs on either side push the components towards the ball to hold it securely in place.
How do you remove a captive bead ring without pliers?
Grab the jewelry by ring with the index and thumb of one hand. Grab the bead or ball with the index and thumb of the other hand. Pull and apply force in opposite directions causing the tension that the ring has on the ball or bead to break. Once the ball or bead is free, rotate the jewelry out.
How do you put the ball back in a captive ring?
How do you put a captive ring in a piercing?
Inserting Small Gauge and Traditional Captive Rings Pick up the jewelry with both hands. Pull the ring apart slowly. Twist the ring. Slide the ring into the piercing. Twist the ring closed. Snap the ball into place.
What is a hoop earring?
Basically, it’s a circle of wire worn through a permanent piercing made in the lower ear lobe. What differentiates the various types of hoop earrings is the mechanism by which they open and close. Most ear piercings and earrings are very thin, approximately 20g or 18g wire (the bigger the number, the smaller the wire).
What is a captive bead ring?
What Is a Captive Bead Ring (CBR)? A captive bead ring (CBR), ball closure ring (BCR), captive hoop, or captive ball ring is a common example of body piercing jewelry. 1 lt consists of a hoop with a captive bead that can be inserted and removed to open and close the ring. How to Open a CBR Ring
How do you spin a ball with captive ring pliers?
Squeeze the nose of the pliers closed, closing the ring around the bead in the process. Continue closing the ring until both open ends snap into the dimples of the bead or ball. When the captive ring is properly put together, you should be able to spin the ball with a little resistance.
