Other

How do I program my sensors Simon XT?

author 0

How do I program my sensors Simon XT?

Simon XT – Programming A Door / Window Sensor

  1. Press or until SYSTEM PROGRAMMING then press.
  2. Enter Installer Code 4321 (Call Brinks Home Security® if this code is different)
  3. Press or until SENSORS then press.
  4. Press again to place Simon XT into sensor learn mode.
  5. Remove sensor cover or press button to learn.

How do I program my Simon XT key fob?

You can program a key fob to an Interlogix Simon XT by accessing the System Programming Menu. Put the system in its learn mode and then press and hold the top two buttons on the device. Once the key fob has been learned in, you can adjust its settings and configurations as needed.

How do I install motion sensor in Simon XTi?

How Do I Add a Wireless Motion Sensor to an Interlogix Simon XT?

  1. Enter programming. Starting from the main screen of the Simon XT, repeatedly press the down arrow until the option “System Programming” is displayed.
  2. Add the motion.
  3. Configure the motion.
  4. Exit programming.

How do you reprogram an alarm system?

You can reset your alarm system by powering it down and then powering it back on. This is what is known as a power reset. To power down the system, the backup battery must be disconnected, and the transformer must be unplugged. Then reconnect the battery and transformer to power it back on.

How do you change the battery in a Simon XT Motion Sensor?

Simon XT – Motion Detector Batteries

  1. Press top button then remove sensor from backplate.
  2. Hold top and bottom tabs then pull motion from front cover.
  3. Remove and replace AA Alkaline batteries then replace motion on backplate.

How do I silence low battery alarm Simon XT?

To turn off the trouble beeps at your key pad:

  1. Scroll down on the Simon XT until you see “System Programming”
  2. Immediately press “OK”
  3. Enter your Master Code and press “OK”
  4. It will display “Access Codes”
  5. Press OK (it will start Flashing “ON”)
  6. Press Status 5 times.

How do you silence Simon XT?

Press the STATUS button or arm/disarm the system to silence the beeps.

How do I reset the master code on my GE Simon XT?

You can reset an Interlogix Simon XT to factory defaults by first powering down the panel completely. Then hold down the four top buttons on the panel while the system is being powered back on. If successful, the Simon XT will reboot with its factory default settings fully restored.

author

Back to Top