How do you fix a water inlet valve on a Maytag washer?
How do you fix a water inlet valve on a Maytag washer?
How to Replace Your Maytag Washer’s Water Inlet Valve Assembly
- Unplug the washer and turn off the water supplies.
- Disassemble the machine to access the water inlet valve assembly under the console.
- Remove the water inlet valve assembly.
- Replace the water inlet valve.
- Install the new wire harness.
- Reassemble the machine.
Why is water dripping inside my washer?
You may find a water hose loose, clogged, or damaged behind the washer. Replace the hoses or screens if needed. Check the water valve for any clogs or blockages before replacing it. As a general note, if the water leaks into the washer tub, then the water inlet valve is the cause.
Can you clean a water inlet valve?
There is little that you can do to repair the valve itself, but you can clean the two inlet ports to restore full water flow. You can also test the valve to determine whether it has failed. Replacing a bad valve is a simple job and must be done with parts and procedures that are specific to your washing machine model.
How much does it cost to replace a washing machine water inlet valve?
Machine Inlet Valve Repair A washing machine inlet valve replacement costs $75 to $125.
Why do water inlet valves fail?
Check for clogs in the filter screens in the water inlet valve, which can block water flow. This is a common reason the valve may malfunction and the easiest problem to remedy. Use a flashlight to look inside each of the two hose fitting ports on the water inlet valve—there should be a screen inside the port.
Why is my Maytag washer dripping water?
Common solutions for: My Maytag Washer is Leaking If the drain pump is cracked or damaged, or if the bearings are worn out, the drain pump may leak water. The drain pump is not repairable—if the pump is leaking water, replace it. The tub seal might be torn, causing water to leak from the seal.
Why is my Maytag washer leaking?
