How do you reset the airbag light on a PT Cruiser?
How do you reset the airbag light on a PT Cruiser?
How to Reset the Airbag in a PT Cruiser
- Locate the OBD port that is the same shape as the OBD scan tool’s connector end.
- Plug the scan tool into this port.
- Wait for the scan tool to interface with the computer.
- Unplug the scan tool and start the engine.
Where is the side impact air bag control module or sensor usually located?
Usually, you have two airbag sensors located in the front of your vehicle behind the bumper. There is often also one airbag sensor installed inside of each door of your car.
How do I know if my airbag module is bad?
The most obvious sign that there’s a problem with your airbag control module is the Supplemental Restraint System (SRS) warning light. This is similar to the “Check Engine” light, and it will appear if there is an issue with your SRS.
What is an airbag control module?
An SRS airbag module, also known as the airbag electronic crash unit, controls the airbag’s deployment, stores crash data and exchanges information with the car’s engine. If your airbags have deployed in an accident before, or if your airbag light is on, you will need your SRS airbag control module reset.
How do I turn my airbag light off?
How to Turn Off the Airbag Light
- Turn on the ignition switch with your car key.
- Wait for the airbag warning light to turn off.
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
Will disconnecting battery reset airbag light?
No, this information is stored in non volatile memory. The airbag light is usually on if there’s a problem with the system. Even if you could clear the code which is reporting that, if the problem isn’t fixed then it will just be detected again, and the light will come back on.
Where are the airbag sensors in a car?
front
An impact sensor is normally fitted to the front of the vehicle as this is where a collision is likely to occur. The sensor is positioned inside the engine and a similar safety sensor is located inside the passenger zone of the vehicle.
How much does it cost to reset an airbag module?
At the very least, the ECU or airbag module will need to be reset costing about $50 to $150. If the airbag control module needs replacing, expect to pay anywhere from $400 to $1,200 for a new one.
Can you drive car without airbag module?
While a vehicle can still run without an airbag module, it is strongly recommended that drivers do not operate the vehicle without it being installed—unless an emergency situation arises and there is no other option. Without airbags deploying, a driver and any passengers can face severe injury or even death.
Does airbag module need to be replaced?
Any crash sensor which may have sustained any type of damage, as a result of an accident, should be replaced. Having the airbags deployed during an accident will obviously mean the airbags need to be replaced. This will, also indicate that airbag control module will need to be replaced and/or reprogrammed.
How do I install the airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs. Wait 3 minutes before installing the airbag module in the vehicle.
What does the SRS light mean on a PT Cruiser?
When the Supplemental Restraint System (SRS) light illuminates on the PT Cruiser’s instrument cluster, it is because an error code is being sent to the On-Board Diagnostics computer from a sensor in the airbag system. Error codes are used to diagnose problems with the vehicle.
Is it safe to unplug airbag control module harness wiring plugs?
You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors.
