What do I do if my Apple home button is stuck?

What do I do if my Apple home button is stuck?

Twist and Spin the Device for a Stuck iPhone Button Take it out of its case, if it is in one. Hold the Home button down firmly. Then, twist the phone in a clockwise motion. Apple recommends this method because it can loosen the button in its holding circle if it has become jammed.

Can the home button on an iPhone be fixed?

iPhone Home buttons do go wrong from time to time, often (frustratingly) a year or so after the warranty runs out. Apple may be able to repair the hardware, but this can be expensive – perhaps to the point where it would be more sensible to spend more and get an entirely new device.

How do you get the home button on the screen for iPhone 4s?

How to Add Touchscreen Home Button on iPhone, iPad

  1. Open Settings.
  2. Go to General > Accessibility.
  3. Scroll down to the section labeled INTERACTION and tap on AssistiveTouch.
  4. On the next screen, toggle AssistiveTouch to the green On position.
  5. A white circle with a grey box will appear on screen.

How do I unstick my phone buttons?

Try scraping-out dust and gunk around the volume control with a q-tip. You can also vacuum the iPhone volume button stuck or use compressed air to blow the dirt out. This is one of the most common reasons that the volume button stops working, so try cleaning your phone first.

How do I disassemble my iPhone 4?

Power off your iPhone before beginning disassembly. Your iPhone 4 rear cover may have either two #000 Phillips screws or Apple’s 5-Point “Pentalobe” screws ( second image ). Check which screws you have, and ensure you also have the correct screwdriver in order to remove them.

How do I replace the home button on my iPhone?

De-route the home button ribbon cable through the inner case and remove the home button from the iPhone. When installing a new part, there may be a protective plastic film on the home button. It can be removed with a spudger or your fingernail.

What happens if you break the iPhone 4’s glass?

It appears that if you break the glass, you’ll have to replace the iPhone 4’s glass, digitizer, and LCD as a single assembly. Surprisingly, the electronic home button switch is attached directly to the home button itself. The 30-pin dock connector is where we would usually expect it to be: at the bottom of the iPhone.

How do I remove the iPhone 4 rear cover?

Your iPhone 4 rear cover may have either two #000 Phillips screws or Apple’s 5-Point “Pentalobe” screws ( second image ). Check which screws you have, and ensure you also have the correct screwdriver in order to remove them. Remove the two 3.6 mm Pentalobe or Phillips #000 screws next to the dock connector.

author

Back to Top