What does chlorinator off no flow mean?
What does chlorinator off no flow mean?
The “No Flow” light indicates that the flow switch is not detecting sufficient water passing through. Check the following: cleaning the cell or the filter (see how to backwash a DE Filter or Clean a Cartridge Filter). Replace the flow sensor.
Why is my chlorinator off?
Air that has entered the system elsewhere, usually through a leaky O-ring in the pump, may be trapped in the chlorinator canister and cause an air lock. This will become evident by unscrewing the canister lid with the pool pump turned off. After the canister fills with water, the lid should be reinstalled.
Can I turn my chlorinator off?
You should never turn on your salt chlorinator until you have balanced your pool’s water and all levels are within range. It is important to maintain salt and chlorine stabilizer levels in order to prevent scaling and to maximize system effectiveness and life.
How do you fix a no flow pool pump?
If your pump looks like there is no water in it, turn it off and unscrew the pump lid without losing the o ring. Fill up a bucket with pool water and pour it into the pump, this is called priming. Once the water level reaches the top, replace the pump lid with the o ring and turn your pump back on.
How can you tell if your chlorinator is not working?
Test the water that water has just left the chlorinator – it should have a very high chlorine reading. (Remember that if it is extremely high it may bleach the test tablet so you may have to dilute the water you are testing). If there is no chlorine reading, the chlorinator will not be working.
How do I know if my chlorinator is not working?
When the saltwater chlorinator fails, it cannot produce enough chlorine to meet the swimming pool needs….Signs that indicate that your system is not working include:
- Low chlorine levels in the pool water.
- No Flow indication on the flow monitor.
- Corroded plates.
- Indicator lights signaling cell damage.
How do I reset my salt system?
Turn Salt System Off and On With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process.
How do you reset inspect on Hayward?
If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
What should my Hayward chlorinator be set at?
How much salt does the system require? Salt Systems work best with approximately 3200 parts per million (ppm) of salt, which is roughly the equivalent to a teaspoon of salt per gallon. However, all Hayward Salt Systems are designed to operate with salt levels anywhere from 2700 ppm to 3400 ppm.
