What does it mean when my Whirlpool washer says F02?
What does it mean when my Whirlpool washer says F02?
long drain time
The F02 error code on a Whirlpool washer indicates that the control detects a long drain time. This can be caused by excessive suds in the tub, a restriction or clog in the drain system, or by a number of other component failures.
How do I reset my Whirlpool Duet front load washer?
Unplug the washer for 30 seconds to attempt to reset the Duet washer control. if your fill hoses have a flood stop check valve turn the water off, disconnect the hoses and run a little water into a bucket. Then reconnect the hoses to your washer and do a Duet Washer Quick Diagnostic Test.
How do you reset the code on a Whirlpool Duet dryer?
If your Whirlpool dryer displays a “PF” error code, indicating a recent power failure, the dryer will need to be reset and restarted. This is done by pressing “Start” for a few seconds to restart the dryer. If the dryer does not restart automatically, select a new cycle and any options then press “Start” to begin.
How do I fix F02?
Press the pause or cancel button on the Whirlpool washing machine to clear the F02 error code from the display, and try using it again. The error code is displayed when the washer takes more than eight minutes to drain, but may just be a glitch.
How do I fix APC F02 error?
BACK UPS pro 1500 error ode f02 after shutdown for the night,…
- just power off your APC.
- just remove the power cord from sector, keep battery.
- press constantly power button until you hear the second beep signal.
- Let the apc restart, it will mark f02 error again.
- plug the power cord.
- restart the APC.
How do you run a diagnostic on a Whirlpool Duet washer?
Whirlpool Duet Diagnostic Test Mode Close the washer door. Select any one key except “Stop/Cancel” and Control Lock. If you got it right all the lights on the Duet washer’s control should light up, and any error codes in the washer’s memory will be displayed.
Is there a reset button on Whirlpool front load washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
Do Whirlpool washers have a reset button?
Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.
How do I turn off the control lock on my Whirlpool Duet dryer?
The Easy Fix
- Locate the “End of Cycle Signal” button. This is located on the right side of the Duet model dryer.
- Push the button and hold it down for 3 seconds.
- The Control Lock LED should turn off letting you know that your dryer is no longer locked.
