How do you install fence posts without cement?
How do you install fence posts without cement?
Procedure:
- Find a concrete surface and lightly tamp your digging iron against it.
- Remove the turf and topsoil from the site of the post.
- Dig the hole putting the displaced earth onto the tarp.
- Pour 4 inches of gravel into the hole.
- Place the post in the hole.
- Add another 2 inches of gravel around the base of the post.
How deep should a post be in the ground?
Dig post hole so diameter of the hole is 3 times the width of the post (i.e., the hole for a 4” wood post should be about 12 inches wide). The depth of the hole should be 1/3-1/2 the post height above ground (i.e., a 6-foot tall fence would require a hole depth of at least 2 feet).
How do you make sure a pole is plumb?
Hold a carpenter’s level against all sides of the post to ensure it is plumb, or straight up and down. Once you are sure the post is plumb, fill the hole with concrete. Take care not to disturb the post as you add the concrete. Check the post again with the level to make sure it is still plumb, and adjust if necessary.
How deep do post holes need to be?
How to calculate post hole concrete?
How to Calculate Cement for Post Holes Use the first drop down to select a size for the post. Use inches in the next two number boxes for a diameter and a depth for the post hole. If there is more than one post hole, then change the value from one. If bagged concrete will be used then select a size for the bags. See the example video below for more information.
How many bags of concrete per fence post hole?
Hereof, how many bags of concrete do I need for a fence post? Also 1-1/2 bags per hole is about right for a 4×4 fence post. Also remember, the depth of the post hole should be one-half of the above-ground post height. (Example: For a 6′ above ground post, use a post with an overall height of 9 feet and place 3 feet in the ground).
Should I use gravel at bottom of post hole?
Finer gravel will provide a more secure bottom for the fence post to set on. If the gravel is too fine, however, water will not drain through as well and may end up collecting around the fence post. For this reason, gravel mixed with sand, and extra fine gravel should be avoided. Pea gravel is commonly used for fence post holes.
How do you repair small holes in concrete?
Remove large chunks of broken concrete and sweep out the hole with a stiff broom; flush it thoroughly with water from a garden hose. Then remove standing water with a sponge.Mix ready-mix concrete according to the manufacturer’s instructions; use sand mix for small holes and gravel mix for large or deep ones.
