How do you replace a mechanical seal on a pump?

How do you replace a mechanical seal on a pump?

Here is a step-by-step process to achieve the task:

1. Disconnect the pump first. Before doing anything, disconnect the pump first.
2. Unscrew the bolts and take the pump out. Using a wrench, unscrew the pump bolts around the housing.
3. Remove the seal.
4. Replace the seal.
5. Put everything in place again.

When replacing a mechanical seal on a pump it is important to?

Replacing the Mechanical Seal on Your Centrifugal Pump

1. It is I, Inspector Pumphead!
2. The main purpose of the mechanical seal is to prevent leakage.
3. The first step of replacing your seal, is to make sure the power to your pump is off because safety is always the first step.

When should I replace my mechanical seal?

The most obvious indicator that the mechanical seal on your equipment needs to be repaired or replaced is a spraying leak. If water is spraying by the shaft seal, there is definitely a need to have the mechanical seal checked out.

Why do mechanical seals fail?

A mechanical seal might fail due to poor lubrication, or no lubrication at all. When there is no liquid around the seal it will be subjected to increased amounts of friction which will increase the temperature inside the pump.

What is the function of mechanical seal in pump?

Mechanical seals are devices that are used to provide a seal at the point of entry or exit of a rotating shaft. Typically it is used to prevent the leakage of one high pressure fluid into a lower pressure fluid.

How long will a mechanical seal last?

Most seal manufacturers say that operation of the seal at one of these limits will result in a minimum life span of two years; three years with some seal types such as those specified in Standard API 682.

Do mechanical seals need lubrication?

1. Mechanical Seals Need Lubrication and Parallel Faces. A mechanical seal is mysterious to most users, but its design is very simple. If the pumpage does not provide sufficient lift or lubrication, a seal support system is used to supply a lubricating fluid.

Why are mechanical seals fail in the pump?

A mechanical seal might fail due to poor lubrication, or no lubrication at all. When there is no liquid around the seal it will be subjected to increased amounts of friction which will increase the temperature inside the pump. This rapid increase in temperature can cause burnt elastomeric parts and damage o-rings or rubber on the seal.

What is the working principle of mechanical seal?

Rotating&Stationary Primary Sealing Elements. The more common end- or rotating-face mechanical seal designs feature mating faces as the primary sealing elements.

Closing Forces.

Static/Dynamic Secondary Seals.

Design&Material Selection.

Process&Environmental Controls.

Equipment Optimization.

What is mechanical seal for the centrifugal pump?

Mechanical Seals in Centrifugal Pumps Introduction The mechanical seal acts as a check valve and a slider bearing. Seal Life Since the seal must function as a slider or friction bearing, the seal has an unpredictable life span. Abrasives The number one enemy of a mechanical seal is abrasive particles in the liquid being pumped. Heat Damage

How do mechanical seals in lobe pump work?

When lobes exist the mesh,an expanding volume is created on the side where the fluid is drawn in,thus determining it to enter the cavity.

The fluid flows through the space created between the lobes and the casing.

The fluid is eventually pushed out through the outlet opening,under the pressure created by the movement of the lobes.

https://www.youtube.com/watch?v=NeXO4B7_J5E