What transmission is in 1991 Land Cruiser?
What transmission is in 1991 Land Cruiser?
This 1991 Toyota Land Cruiser has been with its current owner since 2012, and has a LS1 5.7-liter engine, that’s backed by a 4L60E four speed automatic transmission.
How do I find my Toyota OBD1 code?
Summary
- Park vehicle and set the emergency brakes.
- Turn key to position II.
- Pull the hood release and open the hood.
- Locate the diagnostic port in the engine bay.
- Use a copper wire or paper clip to short terminals TE1 and E1.
- Go back inside the car and count the number of flashes for the check engine lightengine light.
How do Toyota name their engines?
The company follows a naming system for their engines: The first numeric characters specify the engine block’s model (usually differed by displacement) The next one or two letters specify the engine family.
How to gather Toyota OBD1 codes and definition table?
Easy step by step guide on how to gather Toyota OBD1 codes and definition table. Step 1 – To gather trouble codes locate the diagnostic connector under the hood near passengers fender, or under the dash on the driver’s side. Step 2 – Use a jumper wire connect the TE1 and T1 terminals (For Tercel and MR2 use the T and E1 terminals).
What do the flashes on the 1991-94 trouble code table mean?
1991-94 – jump DLC terminals T and E1 with a short lead 2 Count MIL flashes and compare with trouble code table First flashes of 0.5 second duration indicate ‘tens’, after a 1.5 second pause, next flashes of 0.5 second duration indicate ‘units’ After a 4.5 second pause, trouble codes will be repeated
How do you clear the error codes on a Dodge Charger?
Trouble codes can also be cleared by disconnecting the vehicle battery. However, other memory functions (clock, radio, etc.), will need to be reset. After the codes are cleared, road test the vehicle (as applicable for the fault) and recheck if any codes reset. If so, it indicates that the trouble area has not been repaired correctly.
What are the error codes on the ECU?
Code 11 Momentary interruption in power supply to ECU (electronic control unit or computer) up to 1991 Code 13 Rpm signal to ecu missing above 1000 rpm Code 31 and 32 Air flow meter circuit or Vacuum sensor signal fault
