What is the corner radius of rectangular tubing?
What is the corner radius of rectangular tubing?
10.6 Radius of Corners—For square or rectangular structural tubing, the radius of any outside corner of the section shall not exceed three times the specified wall thickness.
Can HSS be round?
HSS members can be circular, square, or rectangular sections, although other shapes such as elliptical are also available. HSS is only composed of structural steel per code.
How do you find the radius of a square tube?
Tips. Dividing the side of any square in half and then multiplying by 1.414 is a quick way to calculate the radius.
Is HSS hot or cold rolled?
HSS, or, Hollow Structural Sections, are cold-formed, welded steel tubes used for welded or bolted construction of buildings, bridges, and other structures as well as a wide variety of manufactured products. They are produced in square, round, and rectangular shapes to meet structural design requirements.
What is a HSS steel column?
Hollow Structural Sections (HSS) are manufactured hollow steel sections, typically of circular, rectangular, or square cross-section. Popular uses include architecturally exposed structural steel, staggered truss and conventional truss structures, and basic column or vertical bracing elements.
What is HSS round?
Hollow Structural Sections (HSS) are manufactured hollow steel sections, typically of circular, rectangular, or square cross-section.
How much of a radius do different shapes of HSS have?
Anybody know where to find out how much of a radius different HSS shapes have at their corners. I know this depends on the thickness of the tube wall. In the welded joint tables, the flare bevel weld shows that the radius C is three times the thickness, which could be 1-1/2″ for a 1/2″ thick wall.
Where can I find information on corner radius tolerances for HSS?
Further information on corner radius tolerances can be found in Part 6 of the Handbook, including tolerances for HSS produced to ASTM A500 and A1085.
What grade of steel is used in round HSS?
Round HSS are usually ASTM A500 Grade C (Fy= 46 ksi). They are available in cross sections matching each of the cross. sections for ASTM A53 Grade B steel pipe.
What is the radius of a corner in ASTM A500?
For HSS produced to ASTM A500, the radii are based on the design wall thickness, taken equal to 90% of the nominal value. The maximum exterior corner radius permitted by the G40.20 standard varies from two to four times the wall thickness, depending on the section perimeter and wall thickness.
