How do you disassemble a Glock?
How do you disassemble a Glock?
Read your Glock owners manual. Field strip your Glock. You will need a Glock disassembly tool or a 3/32” punch, to take apart your pistol completely. Using a disassembly tool push down the polymer spacer sleeve as shown. Hold the sleeve down for the next step.
How do you remove the spring from a Glock magazine?
You’ll notice a rod–which is the spring for the magazine catch. Bring the rod over to the slot on the side and just pop your spring out. Then you just push the mag catch button through. To remove the spring, use your needle nose pliers and just pull it out.
How do you remove the trigger from a Glock trigger?
Holding the trigger housing in one hand, and the trigger bar in the other; pull the trigger bar straight back toward the ejector end of the trigger housing, and then rotate the bar out and away from the housing. This will disconnect the trigger from the trigger housing, now remove the trigger bar from the spring.
How to remove the lock pin from a Kryptek gun?
Push the Lock Pin Out Brace the lower part of the gun onto a bench block or a roll of duct tape. We will drive the pin from the left side of the firearm out to the right side. We also start by pushing the locking block pinout. Full design covering the whole hat with various shades of Kryptek Camo Step 4.
How do you take the slide off a field stripped Glock?
A basic field stripped Glock Slide In order to pull down the takedown tabs and separate your slide from lower receiver, you will need to dry fire the weapon to disengage the striker. Once dry fired, pull the slide back about a quarter inch, and simultaneously pull down the takedown tabs and pull the slide forward off of the lower.
How do I change the backstraps and grips on my Glock?
If you have a Glock Gen 4, or a Glock Gen 5, this is also the pin that you can remove to change your backstraps and grips. The trigger assembly at this point should just lift out of the frame.
