How do you reset a FloodStop valve?
How do you reset a FloodStop valve?
To reset the system after the problem has been fixed, simply wipe the sensors dry and press the green “open” button on the control unit. Certified safe for drinking water applications.
What does it mean when FloodStop is beeping?
According to the instructions, this is a low battery alarm.
What is a flood stopper?
The FloodStop for water heaters automatically shuts off the water supply to the water heater and sounds an alarm, leaving all other household fixtures and appliances operational. Easily prevent water damage from leaking water heaters, water softeners, or even the water main!
How do you mute in FloodStop?
The red light will continue to flash if you push the button to silence the alarm. The FloodStop Valve will remain closed until you push the open button. The Leak Sensor needs to be dry before the FloodStop Valve can be opened.
How do I stop my FloodStop from beeping?
The low battery indicator light will now stop flashing and the beep will stop. – Unplug 6-pin connector from Control Panel and reconnect. – Locate plug connection between Control Panel and the FloodStop Valve that does not operate. Unplug the connection and reconnect, making sure arrows on side of plugs line up.
Should FloodStop be open or closed?
The FloodStop Valve is closed until you push the open button. The leak sensor needs to be dry before the FloodStop Valve can be opened. The Leak Sensor can be dried off without the need for the AC Adaptor to be plugged in.
How do you turn off a water heater alarm?
If you have an electrical unit, you need to turn off the circuit breaker to your hot water heater (it will either be located on your main circuit breaker panel or, less often, near the heater itself). With a gas unit, twist the dial near the thermostat to ‘Off.
How do I install FloodStop?
Connect the 4-pin connector to the FloodStop control unit. Use either the Velcro provided or the screws provided to mount the controller. Attach 2-pin connector to the FloodStop water sensor. Wipe up any water that could activate the sensor and FloodStop system.
Why do water heaters burst?
There are a number of reasons that your water heater can explode; however, the main reason behind water heater explosions is pressure. Anything that causes excess pressure on your water heating system, such as a poor anode rod, or a lot of sediment buildup, can all cause your water heater to explode.
Is water heater water proof?
Although most water heater manufacturers make their units water proof, the seal may deteriorate over time. If you shower with extremely hot water, the steam may also condense on the water heater, causing the seals to wear out.
Can a Floodstop be used with a refrigerator?
A small leak can quickly turn into a major problem if left undetected. These FloodStops were developed for use with refrigerators, icemakers, water dispensers, or anything that uses water and has a 1/4″ compression connection.
How does the Floodstop valve work?
The FloodStop valve is connected to the angle stop and the supply line Water leak sensor is placed at the base of the appliance (ice maker/refrigerator, water filter, etc.) Valve stays open until water leakage is detected Water contact with sensor closes FloodStop valve and sounds alarm
What are Floodstop point-of-use devices?
FloodStop ™ point-of-use water detection devices are an innovative and inexpensive way to help protect you and your home against costly water damage caused by a renegade appliance or exhausted pipe.
Where should I add a Floodstop sensor to my washing machine?
If you want more protection for your washing machine FloodStop valves you can add another sensor behind your dryer or laundry tray/sink or maybe a low spot on the floor where water tends to puddle.
https://www.youtube.com/watch?v=svNV56jsSQA
