How do you attach a ledger board to brick veneer?
How do you attach a ledger board to brick veneer?
To attach a ledger against a wall through brick veneer:
- Mark anchor locations on your ledger and drill through the board with a ½” bit.
- Position the ledger against the wall and mark the anchor positions through the hole onto the wall.
Can you attach a deck ledger board to brick?
You should never attach a deck to a brick wall. Under many building code authorities, even connecting through the brick to the framing behind is not acceptable. The brick veneer must have a minimum of a 1-inch air space between the brick and the framing, but it can be up to 4.5″.
Can you put a deck on a brick house?
On brick houses it is fixed directly to the brickwork. Deck building tip: Before installing a ledger board on a timber framed house, you’ll need to remove any siding from the section of the house the board will be sitting on. This includes standard siding, stucco, and any other barriers.
Can you use sleeve anchors in brick?
Sleeve anchors are versatile. These anchors can be used in a variety of base materials such as concrete, brick and block. The design of the fixings will determine where they can be used, with stainless steel sleeve anchors more suitable for outdoor, wet environments and zinc plated anchors for indoor, dry environments.
How do you attach a ledger board to a block wall?
Use a wood bit to drill ½” pilot holes through the ledger board. Next, use a concrete bit to drill into the concrete wall. Install two bolts at the end of each ledger board. Hammer the sleeve anchor through the ledger board into the concrete wall.
Should I bolt a deck Ledger board to brick veneer?
A.Christopher DeBlois, P.E., an engineer with Palmer Engineering in Chamblee, Ga., responds: Whenever there is a design alternative, I generally recommend against bolting a deck ledger board to brick veneer. I prefer to provide independent support adjacent to the house, usually with posts and beams.
What are the requirements for a ledger connection on a deck?
Oversized holes through the brick veneer are required in this ledger connection detail to prevent loads from being placed on the cladding. Joists must be shorter than 6 feet, and lateral load anchors are also required when the deck is taller than 2 feet above grade.
Can you put a deck on a brick wall?
You should never attach a deck to a brick wall. In other than very old homes, exterior brick walls are only a single wythe (layer) of brick veneer. Brick veneer is not designed or allowed by building codes to support anything other than the weight of the bricks above. The problem is in lateral stability.
Can brick veneer be used as a lintel for a deck?
That way the brick veneer is not forced to carry the weight of the deck, so there is no violation of the lintels section of the CABO code. Although I’m against bolting the deck ledger to or through the brick veneer, I recognize that it’s not an uncommon detail and that building officials often approve it.
