How do you reset the tire pressure light on a 2016 Chevy Sonic?
How do you reset the tire pressure light on a 2016 Chevy Sonic?
Follow these instructions to get started:
- Turn the ignition key to the “ON” position without starting the engine.
- Press the MENU button repeatedly until you see the VEHICLE tab menu on the display.
- Scroll down to the “TIRE PRESSURE” menu.
- Press and hold the SET button to enter the relearn mode.
How do you reset the tire pressure sensor on a 2012 Chevy Sonic?
To reset the tire pressure monitor or tpms system in your 2012 Chevy sonic vehicle, turn the ignition key to the “on” position and depress the tpms button, usually located under the dash, until the tpms light blinks several times.
How do I program my Chevy TPMS?
Turn your vehicle’s key to the “On” position without starting the vehicle. Push the TPMS reset button until the tire pressure light flashes three times, then let go. Start the car and wait for about 20 minutes for the tire pressure sensor to refresh.
How do you reset the tire pressure light on a 2015 Chevy Sonic?
To reset the tpms on the 2015 Chevy sonic make sure the tire pressure is correct, then turn on the vehicle. Now hit the reset button that is to the right of the steering wheel and wait ten minutes. In some cases you may need to hold the button down till the light flashes.
How do you reset the tire light on a 2017 Chevy Sonic?
How do you reset the tire pressure sensor on a 2015 Chevy Sonic?
How do I reset the TPMs on a Chevy Sonic?
Chevrolet Sonic TPMS Reset Procedure. Use the MENU button to select the VEHICLE INFORMATION menu in the DRIVER INFORMATION CENTER (DIC). Use thumbwheel to scroll to the Tire Pressure menu item screen. Press the SET/CLR button to begin sensor matching process. A message requesting acceptance of the process should display.
How do I relearn the tire pressure sensor?
Once you are in the VEHICLE INFORMATION MENU, use the ∧∨ (on the turn signal lever) to scroll to the Tire Pressures screen. 5. Press the SET/CLR button, located at the end of the turn signal lever, to begin the sensor matching (relearn) process. A message asking if you are sure you want to relearn should display.
How do I use the Pro+ tool to relearn the Horn?
Starting with the LF tire, use your Pro+ Tool to scan each sensor in the following order: LF, RF, RR and LR. The horn will chirp, after the vehicle has received a signal from each sensor. After activating the LR tire, the horn will chirp twice signifying the relearn is complete.
