Why is my SpiroVent leaking?

Why is my SpiroVent leaking?

Usually when this happens the expansion tank is in the wrong location and the temporary pressure imbalance when the pump turns off causes the head to flood and the stream of water. If the head needed cleaned the Spirovent would drip and have no bearing on what the pump is doing.

Can you clean a Spirovent?

2. To clean the vent head, use a mild detergent and water or vinegar and water solution. For extremely dirty conditions, soak the head in mineral spirits for several hours and then clean thoroughly. The vent head is available as a replacement part if necessary.

Where do you put Spirovent?

In hydronic heating systems, the Spirovent should be installed in the boiler supply line where the temperature is highest. Should the circulator be located on the supply line as well, the Spirovent should be installed between the boiler and the circulator where pressure is also the lowest.

How does an air and dirt Separator work?

Air and dirt separators remove both air bubbles and dirt particles in one unit. This combination of two functions in a single unit allows savings in time and cost. An excess of air in your system can lead to noise and also to oxidisation, which in turn can lead to the build-up of contaminated particles.

Why air Separator is used in chilled water system?

Air Separator are used with these tanks to facilitate Separation of dissolved air from chilled water so that it can be removed along with air bubbles present in chilled water. It ensures good heat transfer & long trouble free life in the chilled water lines in addition to reduction in noise.

Are air separators necessary?

Without an air-separator, the constant air-water mixture being pumped will dramatically decrease heat transfer capabilities because air acts as an insulator. In addition, oxygen causes contamination. Air in a hydronic system contains oxygen, which causes corrosion and contaminates the system.

Can you clean a SpiroVent?

What is a SpiroVent?

SpiroVent microbubble deaerators remove the microbubbles and circulating air left behind by automatic air vents, or after bleeding valves.

How do spirovent® air Eliminators work?

The Spirovent® Air Eliminators, using our patented Spirotube® coalescing medium, “scrub” the air from the system fluid and allows it to break free in a low velocity, low turbulence removal chamber.

How do I select an air and dirt separator?

Proper selection of air and dirt separators is always based upon system flow with pipe size as a minimum. Peak efficiency can only be reached when selecting based upon GPM flow in accordance with any manufacturer’s published data.

How does the spirovent quad work?

The unique construction of this combined unit allows for the removal of both entrained air and dirt particles. The patented Spirotube®, the core of the Spirovent Quad unit, causes air bubbles to rise and collect in the low turbulence air separation chamber before being released via an integral automatic valve.

What are the different types of spirotube?

Simple to install with a straight in-line full flow design it is available in the VDR-M, VDT, and VHT “Dirt” model as a sealed vessel and the VDN and VHN “Drain” model that includes a removable head and tube sheet construction. This allows access to the Spirotube bundle for inspection or cleaning.

author

Back to Top