Common questions

How do I restart PDU?

author 0

How do I restart PDU?

Reset the PDU Metering Unit (Original PDU)

  1. Press and hold the reset button until you see a five-second countdown displayed on the LCD screen.
  2. During the five-second countdown, release the reset button and then tap the button again to force the metering unit to reset.

How do I reset my APC 7900?

APC PDU AP7900 – resetting the password

  1. Press the reset button for 10 seconds.
  2. The light might start pulsing or go out.
  3. Release the reset button and press it again for 1 second.
  4. The light should pulse / go orange.
  5. After a short while (10-20s), the reset will be complete.
  6. Now you can login as apc/apc.

How do I access APC PDU?

APC PDU configuration trick

  1. Use ARP to define an IP address for the PDU, and use the PDU’s MAC address in the ARP. command.
  2. Use Ping with a size of 113 bytes to assign the. IP address defined by the ARP command. For.
  3. Use Telnet to access the PDU at its newly. assigned IP address.
  4. Use apc for both user name and password.

How do I reset my APC login?

Press the Reset button on the back of the card. The Status LED will flash alternately orange and green. Press the Reset button a second time immediately while the LED is flashing to reset the user name and password to their defaults temporarily.

How do I change the IP address on APC PDU?

How do I set up APC PDU?

What is the default password for APC PDU?

The default username and password for apc pdu is “apc”. It is a common username and password and can be used for setup and installation of APC Management Card setup, BOOTP and DHCP configuration, Local access to the control console among others. Please refer to the following page to know more about APC PDU setup.

How do I Reset my APC to factory default settings?

You need to be connected to them via the serial cable / console. Press the reset button and as soon as the status lights start flashing green/orange, press the reset button again, then press Enter on the keyboard until you get a prompt from the unit. The login username/password then is apc/apc.

How do I reset the device to factory default settings?

1. Press reset button with paper clip – only 2 sec is necessary 2. Release reset. Network port LED’s will start flashing. 3. Immediately press reset again, only 1-2 seconds needed. 4. IMMEDIATELY go to the serial console, and start pressing Enter until you see a prompt.

How do I reset the user name and password on AP9606?

(*If you are using an AP9606, proceed to step 7.) Press the Reset button again a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc).

What is the login username/password for APC?

The login username/password then is apc/apc. Edit: the initial button press should be for 10 seconds or so. Thanks for your feedback! Thanks so much for the response.

author

Back to Top