How do you change the governor on a Kohler k321?
How do you change the governor on a Kohler k321?
Loosen the bolt that holds the arm to governor shaft. Hold throttle linkage at carburetor to the idle stop. Clamp vice grip to governor in the clockwise direction. Tighten bolt holding arm to governor rod.
How do you adjust the governor on a?
To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open. Then you would turn the bottom “clip” (which is connected to the governor shaft) counter clockwise. This will set the governor shaft on top of the governor spool.
How do you adjust the governor on a 25hp Kohler engine?
How to Adjust a 25 HP Kohler Governor Engine
- Set the engine on a flat work bench.
- Locate the governor spring to the right of the oil dipstick.
- Pull the spring out of the linkage hole with the needle nose pliers.
- Move the spring upwards one hole towards the governor lever pivot point.
- Start the engine.
How do you adjust the governor on a lawn mower?
What are the maintenance instructions for a Kohler engine?
Maintenance 24 690 30 Rev. D KohlerEngines.com3 MAINTENANCE INSTRUCTIONS WARNINGBefore working on engine or equipment, disable engine as follows: 1) Disconnect spark plug lead(s). 2) Disconnect negative (–) battery cable from battery.
How do you service a Kohler emission control device?
Disconnect and ground spark plug lead(s) before servicing. Normal maintenance, replacement or repair of emission control devices and systems may be performed by any repair establishment or individual; however, warranty repairs must be performed by a Kohler authorized dealer. MAINTENANCE SCHEDULE
Where can I buy genuine Kohler service parts?
Kohler genuine service parts can be purchased from Kohler authorized dealers. To fi nd a local Kohler authorized dealer visit KohlerEngines.com or call 1-800-544-2444 (U.S. and Canada). Maintenance 4 KohlerEngines.com 24 690 06 Rev. K OIL RECOMMENDATIONS We recommend use of Kohler oils for best performance.
How do you add fuel to a Kohler Pro Series engine?
Add Kohler PRO Series fuel treatment or equivalent to fuel tank. Run engine 2-3 minutes to get stabilized fuel into fuel system (failures due to untreated fuel are not warrantable). 2. Change oil while engine is still warm from operation. Remove spark plug(s) and pour about 1 oz. of engine oil into cylinder(s).
