How do I program my Arctic start remote?
How do I program my Arctic start remote?
Cycle key between OFF and ON (do not crank the engine) 5 times within 10 seconds, should receive 1 parking light flash. TAP Lock on first remote, should receive 1 parking light flash; repeat step 2 for any additional remotes. Wait 7 to 10 seconds for 2 parking light flashes to verify exiting programming.
Is Compustar and Arctic start the same company?
Arctic Start, Compustar and Drone Mobile are owned by Firstech LLC.
How do I get the Arctic out of valet mode?
Press and release the foot brake pedal 10 times within 10 seconds. If you see/hear two parking light flashes/clicks, you have exited valet mode. Remove the key from the ignition and attempt to remote start your vehicle.
How do I reset my keyless start?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
How do you program a Nissan remote to a push to start car?
Programming a Push-Button Starter
- With the fob in your hand, get into the driver’s seat, closing the door behind you.
- When you’re ready, press your car’s start button 15 times in quick succession, with no more than two seconds between each attempt.
- After the 15th button press, push the lock button on your fob.
What is valet mode on remote start?
Valet mode is a safety convenience feature standard on all Arctic Start remote start and security systems. Valet mode disables all system features other than lock or unlock; such as, remote start, alarm triggers, and trunk release.
Can you reset a keyless remote?
Press and hold any button on your remote within 20 seconds. Hold the button until the locks cycle and it will be successfully programmed. Do the same thing to reset any additional remotes or remove the key from the ignition to end the programming mode.
How do I reset my car alarm remote?
Cycle the key in the ignition from the “Off” position to the “On” position twice in a row. The alarm will emit a chirping sound after turning the ignition to the “On” position the second time. This will reset the alarm, making it ready for reprogramming (if necessary).
