Why is the drum on my tumble dryer not turning?
Why is the drum on my tumble dryer not turning?
A broken drive belt is the most common reason a dryer won’t spin. To fix this issue, turn the drum by hand. A working belt should provide some resistance, so if the drum turns very easily and loosely, the belt is probably broken.
How do you reset a Zanussi?
Resetting guide: Press the two buttons at the top (soak and pre-wash). At the same time, turn the cycle selector counter-clockwise to the delicate spin cycle. Then release the two buttons and continue turning the selector counter-clockwise all the way round to off (almost one full turn). Try to wash normally.
Why is my Zanussi tumble dryer not working?
When your Zanussi tumble dryer has no power, it could be due to the delay start being enabled. Other causes could be related to the tumble dryer door. If this won’t close properly the start/button will flash and the cycle won’t start. Faulty door hinges and door switches will need to be repaired or replaced.
Why is my tumble dryer not starting on time?
1. It is possible that your tumble dryer has a delayed start option enabled. If your product has a display, you will see the countdown to the delayed start time. If the product does not have a display, a light will flash next to a time symbol, e.g. 4h-8h-12h.
When to replace the drain pump on a tumble dryer?
It will therefore need to be replaced. On condenser tumble dryers, the drain pump serves to evacuate the water produced by the condensation that takes place inside the appliance. If the pump is blocked or jammed, the safety float will end up activating and, after a few minutes, will trip into safety mode.
How do I Turn Off the energy saving function on my tumble dryer?
Check if the energy-saving function on your product is enabled. If the tumble dryer is in energy-saving mode, you will only see a flashing start/pause button. You can disable energy-saving mode by switching the dryer off and on again. Select a drying cycle and press the start/pause button.
Can you reset a tumble dryer thermostat?
Usually, these are not resettable. If the safety thermostat gets tripped, it will stop the tumble dryer heating up; and on some models it will also switch the appliance off and prevent it from being turned back on. The thermostat will trip if the appliance overheats, if the drive belt snaps, if the motor stops working, etc.
