Contributing

How do I setup a static route on my network?

author 0

How do I setup a static route on my network?

Navigate to the Configuration > Network > IP > IP Routes page. Click Add to add a static route to a destination network or host. Enter the destination IP address and network mask (255.255. 255.255 for a host route) and the next hop IP address.

How do I add a static route to my routing table?

How to Add a Static Route to the Routing Table

  1. View the current state of the routing table.
  2. Assume the Primary Administrator role or become superuser.
  3. (Optional) Flush the existing entries in the routing table.
  4. Add a route that persists across system reboots.

How do I create a static route in Fortigate?

To configure a static route:

  1. Go to System > Network > Static Route.
  2. Click Add to display the configuration editor.
  3. Complete the configuration as described in Table 77.
  4. Save the configuration.

How do I add a static route between two routers?

Steps of Configurations:

  1. Login configure page of router.
  2. Type the username and password in the login page.
  3. Click Advanced Routing button on the left side of the screen, then select Static Routing List(in 54Mbps Wireless Router, the name of button is Static Routing).
  4. Click Add New….

What are the options to configure static routing protocols?

To configure basic static route options using the CLI:

  • To configure the switch’s default gateway:
  • To configure a static route and specify the next address to be used when routing traffic to the static route:
  • To always keep the static route in the forwarding table:
  • To prevent the static route from being readvertised:

How do you add a persistent route?

To make the route persistent just add the -p option to the command. For Example: route -p add 192.168. 151.0 MASK 255.255.

What is a static route in networking?

Static routing is a form of routing that occurs when a router uses a manually-configured routing entry, rather than information from dynamic routing traffic. Static routing can also be used in stub networks, or to provide a gateway of last resort.

How do I enable a route in FortiGate?

To configure a policy route in the GUI:

  1. Go to Network > Policy Routes.
  2. Click Create New > Policy Route.
  3. Configure the following fields: Incoming interface. port1. Source Address. 0.0.0.0/0.0.0.0. Destination Address. 0.0.0.0/0.0.0.0. Protocol. TCP. Destination ports. 21 – 21. Type of service. 0x00. Bit Mask. 0x00.
  4. Click OK.

author

Back to Top