How do I reset my alarm 9651?
How do I reset my alarm 9651?
How to reset Scantronic 9651 / 9751 alarm
- Enter your 4 digit code (this will show the alarm cause)
- Re-enter your 4 digit code again- PRESS X.
How do you reset a Cooper Menvier 9651?
To reset your Scantronic 9651 / 9751 alarm after an activation, enter your 4 digit code. This will show the alarm cause. Having read the alarm cause (e.g. ‘zone 3’ activated), re-enter your 4 digit code again followed by ‘X’.
How do I reset my old house alarm?
How Do I Reset My Alarm System?
- Disconnect the backup battery. Open up the system, and disconnect the backup battery.
- Unplug the transformer. Locate the transformer, and unplug it from the wall outlet.
- Power on. Plug the transformer and the battery back in.
What happens if I unplug my alarm system?
If you unplug the transformer, your alarm system will no longer receive power and that should stop the beeping sound for good.
How does the scantronic 9651 work?
The Scantronic 9651 is a grade 2X fully programmable eight zone control panel, with full and part-set options. Up to four keypads can be added to the system, allowing easy operation from any location. When using the 9943 keypad the 9651 can be easily set and unset using proximity tag without the need to remember an access code.
What is an engineer reset on a 9651 alarm system?
The main reason that the 9651 has engineer reset programmed is to prevent someone tampering with your alarm system, so in the case that you open your main alarm panel (for example to replace the alarm battery) then an ‘engineer reset’ message will appear on your alarm.
How do I set the 9651 I-on panel?
When using the 9943 keypad the 9651 can be easily set and unset using proximity tag without the need to remember an access code. Using common keypads and programming style to all i-on panels this entry level panels provides a small wired panel for the installer whose preference is to install a traditional wired system.
How long does a scantronic alarm take to check a keypad?
Because the chips in Scantronic alarms are fairly rudimental, the system takes quite a while (c.20 / 30 seconds) to do a check. When it comes to the 9651, one of the most relevant checks the system is doing is for the remote keypad – especially if you have numerous keypads and an expander.
