Which cable is used in bus topology?
Which cable is used in bus topology?
coaxial cable
Bus topologies use coaxial cable. Bus topology sections are connected with BNC connectors. T connectors are often used to connect the computer to the trunk cable. The T connector can connect the computer to two sections of cable with the bus extending in both directions.
What is the cable type used in the Backbone of a bus topology?
Alternatively referred to as line topology, bus topology is a network setup where each computer and network device is connected to a single cable or backbone. Depending on the type of computer network card, a coaxial cable or an RJ-45 network cable is used to connect them together.
What is multi access bus network?
A bus network is a network topology in which nodes are directly connected to a common half-duplex link called a bus. A host on a bus network is called a station. In order for nodes to share the bus, they use a medium access control technology such as carrier-sense multiple access (CSMA) or a bus master.
Which network topology has a multipoint connection on one cable?
BUS Topology
Multipoint connection is used in BUS Topology. All the devices are connected to a single transmission medium, which acts as the Backbone of the connection. This links all the devices in the network. Here each node has its unique address.
How many cables are needed in bus topology?
If N devices are connected to each other in a bus topology, then the number of cables required to connect them is 1, which is known as backbone cable, and N drop lines are required. The cost of the cable is less as compared to other topologies, but it is used to build small networks.
What kind of cable is used by 10BASE2?
RG-58A/U cable
10BASE2 uses RG-58A/U cable or similar for a maximum segment length of 185 m as opposed to the thicker RG-8-like cable used in 10BASE5 networks with a maximum length of 500 m.
What does a network cable look like?
Ethernet cables look similar to phone cables. The connector is slightly bigger than a phone cable’s connector. At the end of each cable is a small modular plug, often a Registered Jack 45 (RJ45) connector. They have a small lever on the top which helps secure and unclips the Ethernet cable.
What is line topology?
In a line topology—also known as daisy-chaining or bus topology—the host communicates directly with all nodes through one bus line. A standard Ethernet device or switch can be added to the end of the chain if desired and used as normal. This topology offers no redundant links.
How does bus network topology work?
In a bus topology , all nodes in the network are connected directly to a central cable that runs up and down the network – this cable is known as the backbone . Data is sent up and down the backbone until it reaches the correct node.
Is bus topology multipoint?
Bus Topology This topology is a multipoint connection topology where one long cable connects all the nodes in a network.
Which topology needs a multipoint connection?
Explanation : Bus topology requires a multipoint connection.
Which cable used physical star topology?
Summary Chart
| Physical Topology | Common Cable | Common Protocol |
|---|---|---|
| Linear Bus | Twisted Pair Coaxial Fiber | Ethernet |
| Star | Twisted Pair Fiber | Ethernet |
| Tree | Twisted Pair Coaxial Fiber | Ethernet |
