What is a AOD TV cable?
What is a AOD TV cable?
The throttle valve cable, or TV Cable is basically the data cable for your AOD equipped Fox Mustang. It controls the transmission line pressure which determines the shift points & shift firmness. Make sure your TV Cable & bushing are on the up & up before you lose an AOD transmission! …
How do you adjust a shifter cable on a mountain bike?
Here’s how to do it:
- Step 1: Shift into the smallest gear. I also like to drop my cable tension as low as possible.
- Step 2: Adjust the high limit screw, usually marked with an “H”.
- Step 3: Tension the cable properly.
- Step 4: Carefully shift up into the largest gear.
- Step 5: Fine adjustments.
How do I adjust my Lokar cable?
Slide the kickdown cable end stop onto the inner wire. Move the throttle to wide open and hold it there while pulling the kickdown inner wire as tight as possible. Slide the cable end stop up against the kickdown throttle body fitting and tighten the set screw using the supplied 5/64″ Allen wrench.
How do you adjust Lokar kickdown cable?
How tight should shifter cable be?
Holding the cable tightly so it can’t slip, pull up with the pliers to remove all slack in the cable and hold it like this as you tighten the anchor bolt to secure the cable in place. It should now be tight enough so that when shifted onto the large chainring, there’s no rubbing.
Does the Audi AOD have shift timing problems?
Ever since it was rebuilt, Zimmer says the AOD has experienced shift-timing problems. “It upshifts fine from a standing start. The line pressure is on spec, but when slowing down, the transmission does not like to downshift; instead, the car almost dies before it downshifts.
What is a TV-cable adjustment?
On AOD and other transmissions that use a throttle valve (TV) instead of an old-school vacuum modulator, proper TV-cable adjustment is critical for achieving proper shift quality and timing—but a different rear gear ratio, camshaft, and/or vehicle weight than the core transmission’s original stock vehicle application also affects shift timing.
Will Hot Rod fix Zimmer’s Trans shifting problems?
Zimmer’s transplanted AOD trans shifted inconsistently. No one he took it to could fix it. Time for HOT ROD to ride to the rescue. Ever since it was rebuilt, Zimmer says the AOD has experienced shift-timing problems. “It upshifts fine from a standing start.
Where is the TV pressure test port on a Ford AOD?
High idle TV pressure at the trans’ TV test port confirmed the visual diagnosis. To confirm his suspicion, Sanchez tapped into the AOD’s TV-pressure test port on the main case’s passenger side. It’s the second port forward from the rear (arrow).
