Which command displays RIP routes?

Which command displays RIP routes?

The debug IP rip command
Which command displays RIP routing updates? Explanation: The debug IP rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.

Why is RIP not working?

Most of the RIP troubleshooting issues are about missing routing information. Version mismatch: RIP has two versions, both routers should use the same version. Max hop count: When the hop count is 16, the network is considered unreachable. Route Filtering: Filters might prevent RIP updates from beint sent or received.

How do I advertise a default route in RIP?

It is possible to advertise that default route using RIP to other routers in the local network. On R3, we simply need to enter the default-information originate command in the RIP configuration mode. As you can see from the output above, R1 learned about the default route via RIP.

How do I view a route in Windows?

Click Start, click Run, type cmd in the Open box, and then click OK. Type route print, and then press ENTER to view the routing table. Note the interface number of the network interface that you re-added. Type route print to verify that the new default route appears in the routing table.

What does ip route 0.0 0.0 mean?

In the Internet Protocol Version 4, the address 0.0. 0.0 is a non-routable meta-address used to designate an invalid, unknown or non-applicable target. This address is assigned specific meanings in a number of contexts, such as on clients or on servers.

What does show ip route do?

On a Cisco router, the show ip route command is used to display the IPv4 routing table of a router. A router provides additional route information, including how the route was learned, how long the route has been in the table, and which specific interface to use to get to a predefined destination.

What is debug IP RIP?

Use the debug ip rip command to display information on Routing Information Protocol (RIP) routing transactions. The no form of this command disables debugging output. Updates that are sent and received through interfaces of the router are displayed on the terminal if this command is configured.

Which command will advertise the default route in RIP updates?

default-information originate command
You have learned how you can use the default-information originate command to advertise a default route in RIP.

How does IP routing work on a switch?

When IP routing is enabled on your switch, it behaves just like any other IP router. Basic IP routing configuration consists of adding IP addresses, enabling IP routing, and enabling a route exchange protocol, such as RIP.

What is Rip ( Rip routing)?

Routing Information Protocol (RIP) is a dynamic routing protocol which uses hop count as a routing metric to find the best path between the source and the destination network. It is a distance vector routing protocol which has AD value 120 and works on the application layer of OSI model.

How does R1 know what IP address to use?

Above you can see that R1 knows how to reach the 192.168.2.0/24 network, the next hop IP address is 192.168.12.2. It will now do a second routing table lookup to see if it knows how to reach 192.168.12.2, we call this recursive routing. As you can see, there is an entry for 192.168.12.0/24 with GigabitEthernet 0/2 as the interface to use.

Does the switch support the Rip route exchange protocol?

The switch supports the RIP IP route exchange protocol. This protocol provides routes to the IP route table and is disabled by default. For configuration information, see Configuring RIP parameters. IP global parameters for routing switches