How do I fix Error 48 on Brother printer?
How do I fix Error 48 on Brother printer?
Troubleshooting Print Head problem
- Plug out the printer power cord.
- Lift the scanner cover gently.
- Look inside the printer. If there is any paper part jammed, remove it.
- Do check for any scrap beneath the printer head.
- Move the printer head to the center if it is hung in the right or left corner.
How do I fix Print Unable 48?
“Unable to Print 48”
- Using both hands, use the finger holds on each side of the machine to life the scanner cover into the open position.
- Carefully check the left (1) and right (2) hand corners and the center inside the machine and remove any paper scraps that may be jammed.
Why am I getting an error message on my Brother printer?
You can update or re-install the printer driver. According to many Brother Printer users, the Error State is often caused by the corrupting of the printer drivers. The technicians also suggest the same.
How do I fix Print Unable 44?
“Unable to Print 44”
- Confirm the error message appearing on the display.
- Press Stop/Exit to temporarily clear the error message.
- Unplug the machine from the power outlet.
- Print a User Settings Report to test.
- Your machine will require service.
- Transferring stored faxes to another machine.
Why is encoder strip used in an inkjet printer?
The Linear Encoder Strip is a clear film that is etched with a many vertical lines that are read by an encoder sensor located on the Print Head Carriage (see picture below). The sensor and encoder strip work together to report the position of the Print Head Carriage back to the processor on the Control Board.
How do I fix Error 50 on Brother printer?
Remove all the ink cartridges, turn off the printer, turn it upside down and shake it for a few seconds. If “Unable to print 50” is cleared, then do a Print Quality Check Sheet (PQCS). If it is working and prints successfully, then the issue is resolved.
What does unable to print 4F mean?
Error 4F unable to print is message related to the print head, and specifically means that your print head has either an electrical fault or that it has a temperature error.
Why can’t I print 48 on my Brother printer?
The message “Unable to Print 48” will appear on the display for one of the following reasons: i. A foreign object, such as a paper clip or ripped piece of paper, is stuck in the machine; ii. Mechanical malfunction. To attempt to clear the error, continue to step 1.
How to fix brother printer error code 36?
The Brother printer error code 36 appears on the display of the printer when there is a mechanical malfunction. Here is how to solve the issue causing the error message “Print Unable 36”: Turn off your Brother printer, then turn it back on again. Check the display for any errors. If there are no more error messages, continue with the next step.
What does brother error 50 mean on my printer?
Brother error 50 indicates a malfunction of the fuser unit. This could be caused by the fuser unit getting too hot during printing, or not heating up enough in order to print. As a result, the printer is unable to print. To fix the issue, turn the printer off and wait for five to ten minutes.
Why does my Brother printer say “no paper”?
The error message “No Paper” on the display of your Brother printer indicates that the machine is out of paper. However, the error message may persist even after refilling the paper tray. To fix the issue, you need to identify the cause of the error.
