What is fiberglass grating used for?
What is fiberglass grating used for?
Fiberglass grating is often used when there are safety concerns due to liquids or oils on the floor and more corrosive environments needing chemical resistance. Many applications can benefit from fiberglass grating, such as: walkways, platforms, protective shielding, machinery housings, raised floors and stairways.
What is GRP decking?
DeckGrip Max Anti Slip GRP Structural Decking Boards are a long-lasting anti-slip solution to replace the wooden planks on decking. …
What is phenolic grating?
USCG Approved Phenolic grating is an alternative to maintenance-intensive metal grating for applications where conventional pultruded grating cannot be used. The feature makes the grating ideal for a wide range of offshore, marine, transportation and industrial applications.
How strong is fiberglass grating?
In terms of strength, fiberglass grating is comparable to steel. Pultruded fiberglass grating does offer improved strength but with added benefits steel can’t match. For example, even though fiberglass grating is rigid, it is a more flexible material than steel.
How is fiberglass grating made?
This type of grating is created by a series of parallel load bars that are kept parallel by a series of cross rods. These bars are fabricated by pulling fiberglass roving through a pultrusion machine. Then, the fiberglass receives a resin bath, and it is wrapped with a surface veil made out of fiberglass strands.
Can you cut fiberglass grating?
You can cut curves and angles in fiberglass grating the same way. You can use a reciprocating saw or a jig-saw. Again, the key is to use a diamond-tip blade. When you cut FRP grating, the general rule is that you have to re-seal it with polyurethane.
What is FRP flooring?
Fibreglass reinforced plastic (FRP) grating is a type of industrial flooring used across a broad range of industries. Typically it is found in walkways and overhead platforms.
How long does fiberglass grating last?
A: FRP can last a very long time due to its corrosion resistance and UV stability. So, one can expect FRP products to last at least 20-25 years.
How do you cut fiberglass safety?
Unlike other construction materials like plywood, fiberglass requires several precautions for a clean and safe cut. For straight cuts, a table saw or hand-held circular saw is sufficient. However, for curved cuts, a saber saw or hand-held jigsaw will do a fine job.
What is IGRP grating?
GRP Grating is a structural fibreglass grating product that is made by hand using GRP rovings and resin to offer once cured and exceptional grating panel that has the benefit of bi-directional strength.
What accessories are available for GRP grating?
FibreGrid’s Fibreglass Moulded Grating products are available with a selection of accessories for fixing the panels down or elevating them up. J Clamp and J Clamp Set for securing GRP Grating. M-Clips, C-Clips, & L-Clips sets for installing GRP Grating.
Why choose GRP moulded grating?
The grating lends itself to many different applications from service riser grating for open riser shaft voids, overhead walkways and gantries to heavy industrial trench covers. With its many benefits over traditional materials, GRP Moulded Grating should be the ultimate choice for the 21st Century.
What is the purpose of grating on panels?
As the grating is made in a continuous run without the fibres ever been broken, small and medium cut outs of the grating does not effect the panel. The grating lends itself to many different applications from service riser grating for open riser shaft voids, overhead walkways and gantries to heavy industrial trench covers.
