Why is my pool heater not lighting?
Why is my pool heater not lighting?
Heater Pilot Won’t Light? This could be as a result of low gas pressure, inadequate air supply, or improper venting. Ensure that the gas is turned on, and for propane, make sure the tank has fuel. Also, check for water run-off from the roof or sprinklers that may be flooding the pool heater.
Why does my pool heater cycle on and off?
The most common cause of a heater that cycles on and off could be inadequate water flow to a dirty filter or closed valve. (See information on How to Backwash a DE Filter or Clean a Cartridge Filter).
Why is my pool heater clunking?
A common noise made by a swimming pool heater is grinding or grating. You may have an obstruction caused by debris. Debris can prevent water or gas from flowing through the heater. You should start your troubleshooting with a manual flush of your system.
Why is my pool heater making noise?
Occasionally, you may find that your pool heater creates unusual noises. These noises may include unpleasant grating or grinding sounds. If your pool filter is making strange sounds, your system may be clogged or dirty. In addition, strange sounds can be caused by faulty pressure switches.
How do I know if my Raypak heater is faulty?
The majority of RAYPAK heaters will have a digital readout. If there is a safety fault, a fault code will be displayed along with the word “SERVICE” flashing on and off if the PC board detects a known issue. The fault code is displayed in 3 big letters in the lower-left of the digital display.
What does error code 5 mean on PRS Raypak pool heater?
Error Code 5: PRS Raypak pool heater water sw open error could have been caused by several factors. The most notable one is water pressure. If the water pressure is low, the heater may only operate for a short time and cut-off.
How do I Fix my Raypak pool heater water SW open error?
Try unplugging all the wires connected to the board and switch off the heater from the toggle and main switch. Power back on. If it still does not work, change the board entirely. Raypak pool heater water sw open error could have been caused by several factors. The most notable one is water pressure.
What does error code BD1 mean on a Raypak heater?
No one likes to get an error code on any piece of technology, especially on a Raypak heater. It means something is wrong and needs to be addressed soon. The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you.
