How do you manually operate LCI electronic leveling?
How do you manually operate LCI electronic leveling?
How to Enter Manual Mode – Extend:
- Push “ON/OFF” to turn the system on.
- Push the “UP” arrow once, or until the screen reads “MANUAL MODE”.
- Push the “ENTER” button once.
- Push the “FRONT” button to extend the front landing gear legs.
- Push the “REAR” button to extend the middle and rear landing gear legs.
How do I reset my LCI leveling retract timeout?
Expert Reply: If the touch pad is showing “Retract Time out Return Levelers for service” all you need to do is hit, enter and retract at the same time. That will clear that code.
How do I reset my 6 point Lippert?
Troubleshooting Lippert 6-Point Leveling System Reset After Stored Without Power
- Turn “ON/OFF” button “OFF”.
- Push “FRONT” button 10 times.
- Push “REAR” button 10 times.
- Control will flash and beep, LCD says “ZERO POINT CALIBRATE”.
- Manually operate the jacks to attain unit level condition (use carpenter’s level).
How do you fix stroke errors?
To clear the error you can extend all of the jacks in the system at least 6 inches. Then press and hold the retract button until the jacks start to retract. All of the jacks should fully retract and the error should be cleared.
Why is my Lippert 5th wheel RV leveling system not working?
For instance, the Replacement Control Module for Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC304136 is the replacement for the Ground Control System. This sounds like it is a ground issue. If your ground wire from the control module is grounded to the frame, I would try removing the ground and cleaning the surface.
What do I do if my RV leveler is not working?
Make sure your RV is connected to shore power or other power source If power is working and there is still no display, call your dealer for service If the system is physically unable to level the RV because of uneven terrain, an “Out of Stroke”, “Excess Angle”, “Jack Timeout” or “Auto Level Fail” error code will be displayed
What should I do if my Lippert controller doesn’t work?
He said if that doesn’t work then the controller is bad and will need to be replaced. For instance, the Replacement Control Module for Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC304136 is the replacement for the Ground Control System.
How do you check the Trans fluid level?
All the lights start blinking with break off and ignition on. Cannot lower jacks. Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink. Trans fluid level is hard to check as it is transparent on the dip stick.
