How do I get my Sky TV link to work?
How do I get my Sky TV link to work?
Switch your Sky box, and everything connected to it, on at the mains. You should see a red power light on your tvLink. Wait for about four minutes, then switch your Sky box on using your Sky remote. It may take a couple of minutes for your Sky box and TV to work as normal.
How does Sky TV link work?
To use a TV Link, you need to have an aerial cable running from your Sky box to a second TV. The Sky TV Link is a dongle that plugs into a second TV set and has an infrared receiver. Point a Sky remote at the receiver, and it sends a signal down the aerial wire back to a Sky box and changes the channel.
How do I get my magic eye to work with Sky HD?
- Turn off the power to your Sky box.
- Plug iO Link into iO port on the back of your box.
- Connect the iO Link to the TV Link using the coaxial cable.
- Turn the power back on. ( Wait 3-4 mins before trying to take your Sky box out of standby)
What is an iO link for Sky Box?
The IO Link is an adaptor that lets you conveniently connect a Sky Magic Eye (TV Link) to the IO port on compatible Sky+HD boxes with built-in Wi-Fi.
How do I set up DSTV TV link?
When a TV link is plugged in and it does not want to power-on or function properly, the steps below should be followed.
- Press menu button.
- Select advanced option.
- Enter the pin 9949.
- Select equipment setup.
- Select no.3 on the menu (TV Link/Auxiliary)
- There will be two options on/off, this option must be set to on.
What is WPS button on Sky Box?
2 Within one minute press the WPS button on the front panel of your Sky±HD box. Your Sky±HD box should connect to your broadband router automatically. want to connect by WPS, then you can connect by entering the Wi-Fi password: 1 Press services, 0, 5 on your remote control and this will take you to the Network tab.
How does the DSTV eye link work?
TV Links are installed with DSTV SDPVR or HDPVR Decoders using your existing RF / Coaxial cable to control the PVR or decoder supporting TV Links from another room via the DSTV Remote. TV Links are powered from the decoder and does not require external power.
Why does my DStv says no signal?
The reason your DStv says no signal is because there is an error in the DStv installation. This is caused by either a misaligned satellite dish, a faulty LNB, an improperly connected F-connector plug, loose cables or incorrect decoder settings on the LNB type.
