Can FRS radios use repeaters?
Can FRS radios use repeaters?
Although the FCC does not allow the use of a repeater on FRS frequencies (and given the 1/2 watt limitation of channels 8-14 on the FRS and GMRS services, it isn’t practical anyway), it does allow the use of repeaters on the GMRS.
Are GMRS repeaters legal?
These are legal for use in this service as long as they are certified for GMRS under USC 47 Part 95. GMRS licensees are allowed to establish repeaters to extend their communications range.
Are GMRS and FRS frequencies the same?
FRS and GMRS share the same frequency band (462-467 MHz). The frequencies are pre-programmed into 22 channels. Channels 1-7 have a power restriction of 5 watts. Channels 8-14 have a power restriction of .
What repeaters can GMRS use?
Combined with the ability to use repeaters, GMRS can be used to communicate over considerable distances….GMRS.
Lower frequency | Upper frequency | Purpose |
---|---|---|
462.575 | 467.575 | GMRS “575” |
462.5875 | — | FRS channel 2, GMRS “5875” |
462.600 | 467.600 | GMRS “600” |
462.6125 | — | FRS channel 3, GMRS “6125” |
How far do GMRS repeaters?
This repeater service increases the range dramatically, with each individual repeater being able to send out signal up to a 20 mile diameter around it. The range for GMRS radios using repeaters can be up to hundreds of miles.
What frequencies can I use with GMRS?
462 MHz
The General Mobile Radio Service (GMRS) is a licensed radio service that uses channels around 462 MHz and 467 MHz. The most common use of GMRS channels is for short-distance, two-way voice communications using hand-held radios, mobile radios and repeater systems.
Which FRS channel should I use?
FRS channels 1 through 7 overlap with GMRS and can be used to communicate with GMRS radios. If you need to talk only to other FRS radios, use channels 8 through 14 to avoid possible interference with low band GMRS users.
Do GMRS repeaters need to ID?
Each Station must id after each series of transmissions or 15 minutes of talking using plain english or Morse Code. Repeaters are not required to ID as long as the transmissions are IDed, but not vice versa. § 95.21 GMRS system description.