Who shall be allowed to operate a powder-actuated tool?
Who shall be allowed to operate a powder-actuated tool?
employees
Only employees who have been trained in the operation of the particular tool in use shall be allowed to operate a powder-actuated tool.
When using powder actuated fastening systems operators must?
lication 00m/s. During firing of the powder-actuated fastening tool, operators should ensure that all persons, required to be in the immediate vicinity of the firing activities, wear suitable eye and ear protection. Because of splintering base material a hard hat is also recommended.
Which of the following is not a safe practice when using a powder-actuated tool?
Which of the following is not a safe practice when using a powder-actuated tool? Loading the tool before the item is ready to be fastened. Why is it unacceptable to use a powder-actuated tool to fasten a plywood sheet to a wall stud?
What are the four requirements for safe powder-actuated tool use?
Handle powder-actuated tools with the same respect and safety precautions as guns. Use the manufacturer’s information as a guide for safe operation and maintenance of the tool. Wear safety glasses or goggles, or a face shield (with safety glasses or goggles) and a hard hat. Wear hearing protection.
What should you avoid doing when driving fasteners using a powder-actuated tool?
Do not drive fasteners into: Very hard or brittle material such as cast iron, glazed tile, surface-hardened steel, glass block, live rock, face brick, or hollow tile. Easily penetrated material unless it is backed by another material that will prevent the fasteners from passing completely through the other side.
What should you avoid doing when driving fasteners using a powder-actuated tool quizlet?
To help prevent accidents, never load a powder-actuated tool until just before you use it. Choose the powder level carefully. A powder-actuated tool that has too much powder can provide excessive force, which could drive a fastener completely through a wall and have it strike someone on the other side.
What should you avoid when driving fasteners using a powder-actuated tool?
What is a Hilti gun used for?
Powder Actuated tools, such as the Hilti gun or the Ramset gun are very powerful tools used to fasten wood or other material into concrete or steel. A small charge sends a piston, which sinks a pin or fastener into the concrete or steel at a depth that will produce the strongest hold.
Do you need a license to operate a Hilti gun?
While a “license” isn’t required for a Hilti gun, you must have a valid operator’s certificate. You can usually get an operator’s certificate from the tool’s manufacturer or supplier following some training. Each certificate is only valid for the specific make and model of the specific tool.
What is the instruction of operators for powder actuated tools?
Instruction of operators. Before employees are permitted to use powder actuated tools, they shall have been thoroughly instructed by a competent person with respect to the requirements of paragraph (b) of this section and the safe use of such tools as follows:
Can anyone on the job site inspect powder actuated tools?
Can anyone on the job site inspect powder actuated tools before they are used? Only employees that have been trained in the operation of the specific tool in use shall be allowed to operate or inspect the tools and it should be done before each use.
