What is the cross slide used for?
What is the cross slide used for?
The cross slide is a component found on the top of a lathe that allows the tool bit to slide back and forth.
What is a cross slide vise?
A cross slide vise is a flexible vise that allows the jaws to be adjusted without having to remove the base from the machine bed or work table. It has two mounts rather than just one, which distinguishes it from most types of machine vises.
What is a compound slide?
A Compound Slide is used to cut angles or tapers that cannot be cut by “swinging the headstock” (See the Assembly and Instruction Guide, P/N 5326, under the section on Taper Turning). The slide has 1.25″ to 1.75″ of movement, depending on the angle.
What is a lathe compound slide?
The compound slide offers a way to turn tapers and cut angles on a lathe without rotating the headstock. The lathe tool is inserted in the holder “upside-down,” so the cutting tip faces downward. Because of the miniature lathe’s small size, operating the crosslide handwheel in this position is just as convenient.
What is the function of carriage?
The carriage is located between the headstock and tailstock and serves the purpose of supporting, guiding and feeding the tool against the job during operation. The main parts of carriage are: The saddle is an H-shaped casting mounted on the top of lathe ways.
Which of the following part of machine is a cross slide?
Which of the following part of lathe move in a direction normal to the axis of spindle? Explanation: Cross slide move in a direction normal to the axis of spindle during the process of machining in lathe machine.
What is feed rod?
Feed rod is a power transmission mechanism used for precise linear movement of the carriage along the longitudinal axis of the lathe.
How do you adjust a lathe cross slide?
Adjusting Cross-slide Backlash
- Loosen the two outer screws using a 3mm hex wrench.
- Loosen the middle screw using a 2.5mm hex wrench.
- Tighten the middle screw until it is just snug.
- Tighten the two outer screws until just snug.
What are the three main parts of the carriage?
The carriage is located between the headstock and the tailstock and contains apron, saddle, compound rest, cross slide and tool post.
