Why is my Lazy Susan not working?

Why is my Lazy Susan not working?

When a Lazy Susan becomes stiff and difficult to rotate, the problem is usually caused by either the center shaft or the position of its bottom shelf. In this situation, you’ll need to loosen this shelf. If the circular shelves slip down the center shaft, the bottom shelf can begin to drag, making it difficult to turn.

How do you fix a wobbly Lazy Susan?

In some cases, this can be solved by adjusting lazy Susan cabinet door hinges.

1. Loosen the bolt.
2. Move the adjusting rod.
3. Loosen the screws.
4. Lift the shelves to finish adjusting the shelf position.
5. Tightening the screws.
6. Remove the retaining clip to improve top and bottom clearance 2.
7. Turn the adjustment wheel.

How do you adjust a lazy Susan cabinet?

Tighten the collar screw and check for plumb. Lower the upper pole again, then replace the shelves over the pole. Extend the upper pole to the pivot, tighten the collar screw, then reposition the shelves and tighten the shelf screws. Test the lazy Susan to make sure it properly rotates within the cabinet.

How do you remove corner shelves from cabinets?

Tap upward on the shelf with a hammer — if the cabinet has a shelf — until it loosens from the nails or staples. Move the shelf up and down until it comes loose and remove it from the cabinet. Cabinets like this may have two shelves that butt together. Remove both of them the same way.

Who invented lazy Susan?

Elizabeth Howell
Lazy Susan/Inventors

How do you repair a lazy Susan cabinet?

You’ll then be able to remove the pole. Installing the replacement cabinetry is the more challenging part of the job. You’ll begin by installing a Lazy Susan mount at the bottom of the cabinet, then marking where the screws should go. Tthen drill holes for those screws and lock the mount in place.

Loosen the screw on the collar in the center of the pole, and slide the upper section of the pole down into the lower section. Lift each shelf over the end of the pole, and pull them out of the cabinet.

How to adjust a lazy Susan cabinet?

Empty the Cupboard

Locate the Support Bracket. Look under the Lazy Susan shelf and you will see that it is supported by a bracket.

Bracket Screw. Lift the Lazy Susan shelf and you will then see that the bracket is held in place by a single screw.

Adjust the Bracket.

Fix.

How to fix Lazy Susan?

Pinpoint where rotation problems are occurring. When a Lazy Susan becomes stiff and difficult to rotate,the problem is usually caused by either the center shaft or the position

Locate the locking bolt to adjust the center shaft. Look at the top of the center shaft.

Loosen the bolt. If anything is inside your Lazy Susan,empty it so you have more space to work.

Move the adjusting rod. Now that the bolt is loose,you’ll be able to adjust the center shaft.

Tighten the bolt to finish adjusting the center shaft. Use your wrench or ratchet to carefully refasten the locking bolt in place.

Locate the locking screws to adjust the shelf position. Most Lazy Susans should have two or more locking screws located at the center of each shelf.

Loosen the screws. Loosen the locking screws using a Phillips-head screwdriver or similar tool. Hold the screwdriver so its head meets the fastener straight on.

Raise the shelves to finish adjusting shelf position. Carefully lift the bottom shelf or entire shelf system until there is roughly half an inch (1.25 cm) of space between

Tighten the screws. Hold the shelf in place with one hand and use your free hand to tighten the locking screws back in place with a screwdriver.