How do I know what Ford head I have?
How do I know what Ford head I have?
Look for three different locations where your Ford cylinder head code number will be located: on top of the head under the valve cover; on the bottom of the head, requiring the head to be removed; and on the side of the head just under the valve cover lip.
Where are the casting numbers on Ford heads?
The casting number is located under the valve cover, in the middle of the cylinder head. It is a combination of a number and four letters; C6ZZ-A, for example. According to ClassicMustang, casting numbers may change from year to year and are usually the same or nearly the same as the cylinder head part number.
How do I decode a Ford casting number?
In order, here is what each digit in a Ford part or casting number represents:
- DIGIT #1—DECADE OF MANUFACTURE: A – 1940.
- DIGIT #2—YEAR OF THE DECADE:
- DIGIT #3—CAR LINE:
- DIGIT #4—ENGINEERING OFFICE RESPONSIBLE FOR ORIGINAL DESIGN:
- DIGITS #5-9—BASIC PART NUMBER:
- DIGITS #10-12 (SUFFIX)—DESIGN CHANGE:
- TYPICAL DATE CODE:
- 9A21.
How do I know if my engine is a 289?
You need to look for the cast numbers on the engine. Those numbers are located near the place where the startmotor is . That photo could be a 289 or a 302, and there would be no way to tell.
How do I identify a 289 hipo head?
Two dots, not one, cast into the head, valve spring cups cast into the heads, and treaded, not pressed in, rocker arm studs. Those are the easy ways of telling at a glance.
Where are the casting numbers on a Ford engine?
Illuminate the section of the block where Ford stamped the casting number. This is directly beside the starter mount, where the starter motor bolts to the engine. Write down the casting number down with pen and paper.
How do you read Ford engine numbers?
Ford’s part number convention generally follows the format of a four digit casting code, followed by a four digit basic part number, which will be “6015” for an engine block, followed by the revision version.
How do you tell if you have 2V or 4V heads?
4V heads have 2.19″ dia. intake valves, 1.71″ dia. exhaust valves, and larger intake and exhaust ports which allow for easier breathing at higher rpms. 2V heads have 2.05″ dia.
How do I know if I have a 302 or 289?
Just codes. The 289 would be “1M”, and the 302 would be “2M”, or “2MA”. Pull the oil pan and you’ll know.
Are there any non-performance 1966-67 Fe head casting numbers?
This list shows pretty nearly all non-performance FE head casting numbers. There may be another 1966-67 marine variant and there are some 1966-67 truck variants that are not listed. Also, the detail description is lacking, but the intent was to find the casting numbers, not precisely describe it.
How do you find the casting number on a Ford FE block?
Ford FE Casting Numbers. Blocks. The casting number is on the right (passenger) side of the block, in the front. FE (330-428 SCJ) note: nearly all FE blocks have 352 cast on the front of them.
What is the Ford part number for a cylinder head?
Ford’s part number convention generally follows the format of a four-digit casting code, followed by a four-digit basic part number, which will be “6090” for a cylinder head, followed by the revision version.
Can you have the same casting number on two Ford engines?
One thing to note, is that due to the general numbering scheme of Ford’s casting numbers, you can have the same major casting number, for two completely different applications. For example, there is also an E7TE big-block Ford cylinder head, with the revision identifier of “BD.”
