How do you hook up a 4-prong dryer cord to a 3 prong?
How do you hook up a 4-prong dryer cord to a 3 prong?
Instructions
- Remove Coverplate for Electrical Connections.
- Remove the Strain-Relief Fitting.
- Disconnect the Old Cord.
- Separate the Dryer’s Neutral From the Ground.
- Connect the New 4-Prong Cord.
- Attach the Strain-Relief Fitting to the New Cord.
- Reinstall the Dryer’s Electrical Cover Plate.
What kind of plug does a Maytag dryer use?
Because some household laundry rooms are equipped with three-prong 220-volt outlets, while others are equipped with four-prong outlets, these Maytag electric dryers can be adapted to either type. Installing a three-prong power cord on a Maytag dryer takes only a few minutes with some common hand tools.
Does Maytag dryer come with cord?
For the most part, you don’t need a new power supply cord when you’re replacing an old dryer with a new one. Since most new dryers don’t come with a power cord, the appliance salesman might recommend that you purchase a new one.
Which wire is neutral on a dryer?
A 4-wire cord consist of a 4 conductor cable with wires colored coded as Black (Hot), Red (Hot), White (Neutral) and Green (Ground). In a 4-wire circuit, the neutral and ground are isolated. The connections on your dryer should have three connection terminals. Left is hot – middle is neutral – and right is hot.
What size wire do I need for a 4 prong dryer?
A 4-prong dryer outlet is wired as a 120/240-volt circuit. The 120-volt service is for the dryer’s timers, sensors, and other electronics, while the 240-volt service supplies the heating elements. The NEC requires that dryers have a dedicated circuit with a minimum of 30 amps. This calls for a 30-amp, double-pole breaker and 10 AWG wire.
How do you connect a ground wire to a dryer outlet?
Connect the Ground Wire . Connect the ground wire from the dryer outlet’s circuit cable to the panel’s ground bus bar. This involves inserting the bare end of the wire into a slot in the ground bus bar and tightening the set screw to secure the wire. Carefully fold the excess wire and arrange it along the outer edge of the panel.
What are the electrical requirements for a dryer cord?
The cord should be type SRD or SRDT and be at least 4 ft. (1.22 m) long. The wires that connect to the dryer must end in ring terminals or spade terminals with upturned ends. ■A UL listed strain relief.
What size breaker do I need for a 120V dryer?
The 120-volt service is for the dryer’s timers, sensors, and other electronics, while the 240-volt service supplies power to the heating elements. The NEC requires that dryers have a dedicated circuit with a minimum of 30 amps. This calls for a 30-amp, double-pole breaker wired with 10 AWG wire.
