Other

How do you remove the center console on an Audi a4?

author 0

How do you remove the center console on an Audi a4?

DIY: Remove Center Console

  1. Step 0: Put your car in neutral.
  2. Step 1: Remove the climate controls.
  3. Step 2: Remove the trim around the gear-shift.
  4. Step 3: Remove the ash-tray.
  5. Step 4: Remove the arm-rest.
  6. Step 5: Remove the rear HVAC controls.
  7. Step 6: Unbolt the center console.
  8. Step 7: Remove the center console.

How do you adjust armrest on Audi q3?

To adjust the angle, lift the armrest Fig. 1 until it engages in the desired position. To lower the armrest again, lift the armrest slightly from the top click stop and then fold it back down. Then raise the armrest to the desired position if necessary.

How do you remove the center console on a A6 C6?

Keep reading for a detailed tear down of the A6 C6 center console. Follow the side trim of your center console all the way to the front of car underneath the dash. You’ll see a small round cover. Pry open this cover and remove the bolt inside. Then carefully pry the side trim away from the center console using your plastic trim tool.

How do I remove the center console from my car?

Follow the side trim of your center console all the way to the front of car underneath the dash. You’ll see a small round cover. Pry open this cover and remove the bolt inside. Then carefully pry the side trim away from the center console using your plastic trim tool. You’ll need to repeat this for the other side of the console. Figure 1.

Can you replace the MMI control console on an A6?

Replacing an MMI control console is a costly repair just for the parts alone, but you can just as easily install it on your own. Any component in the A6 center console can be easily replaced if you know how to take the console apart. That’s what this guide is for.

How do you remove the ashtray from the center console?

Tighten two bolts on the side of the center console. Pull down gear selector boot and snap it back into position. Return the ashtray and snap it back into position. Tighten the two bolts in the ashtray. Return the cover tray to the ashtray. Return the trim to the bottom of the HVAC unit.

author

Back to Top