What kind of hydraulic fluid does a John Deere take?
What kind of hydraulic fluid does a John Deere take?
Hy-Gard
In the lab and in the field, Hy-Gard is preferred by John Deere engineers to deliver increased performance and protection of transmission and hydraulic systems. Hy-Gard retains proper viscosity over a wide range of operating temperatures thanks to its polymeric viscosity improver.
What type of fluid goes in a John Deere hydrostatic transmission?
Between minus 4 degrees and 122 degrees Fahrenheit, John Deere recommends SAE 20W-50 be used on its products.
How much oil does a John Deere 2320 take?
John Deere 2320 Engine
| Engine Detail | |
|---|---|
| Yanmar 3TNV76 | |
| Compression: | 23.4:1 |
| Oil capacity: | 3.4 qts 3.2 L |
| Coolant capacity: | 3.4 qts 3.2 L |
What weight oil is JD Hy-Gard?
Hy-Gard oil can be used in most applications calling for 10W-30 or 5W-30 engine oil for transmission and hydraulic oils.
What does a John Deere 2320 weigh?
John Deere 2320
| Dimensions & Tires | |
|---|---|
| Wheelbase: | 63 inches 160 cm |
| Weight: | 1660 lbs 752 kg |
| Front tire: | 23×8.5-12 |
| Rear tire: | 31×12-16.5 |
What color is John Deere hydraulic fluid?
John Deere Hygard Lo-Vis. Hydraulic fluid used to be colored RED to make it easier to see in the sight glass. Deere sells the dye in small bottles, but I don’t think most dealers stock this item. It can be ordered from Deere and sells for around $4.75 per bottle.
How do you add hydraulic fluid to a John Deere tractor?
Change the fluid
- Drive the tractor to let the engine warm-up.
- Get your hydraulic equipment ready.
- Remove the drain plug to drain the fluid.
- Clean the screens.
- Replace the filter.
- Place the plug back in.
- Refill with hydraulic fluid.
- Let the engine run for 30 seconds to 1 minute.
