How wide is a standard deck railing?

How wide is a standard deck railing?

42″
California is the one exception. The requirement there is 42″. There are a few additional minimum height and width requirements to keep in mind, especially if you’re interested in DIY-ing your railing.

What is code for railing on a deck?

What Is Code For Deck Railing Height? The IRC requires guardrails to be at least 36 inch in height measured from the deck surface to the top of the rail. Commercial decks attached to multifamily buildings regulated under the International Building Code (IBC) require 42 inch high guardrails.

What size is deck railing?

Deck stair railing should stand at least 34 inches high, measuring vertically from the nose of the stair tread to the top of the rail. The IRC specifies that deck stair railing should measure between 34 and 38 inches high, so homeowners may wish to use railing that is even higher than 34 inches for their deck stairs.

What is the standard spacing for railings?

In order to comply with building regulations and codes, balusters must be spaced no more than 4 inches apart on center. The general rule is that your railing must have three balusters per foot (every 12 inches), although you can place them closer together if you’d like.

What is code for deck post spacing?

U.S. building code requires support posts for the rail structure to be no further apart than 6 feet on a deck with 4×4′ deck rail posts and no more than 8 feet apart for decks with 6×6′ deck rail posts. Posts should be no further apart than 5.5 feet on stairs.

How do you measure a deck railing?

Measure the distance between the corner posts of your deck with a measuring tape. If you plan to install railings on multiple sides of the deck, measure the length of each section you wish to rail.

How far apart should deck railing posts be?

Secure the Posts Maximum spacing of posts is 72 inches on center. Bolts should be vertically spaced no less than 5-1/8 inch apart. For a composite railing system, slide the post sleeve over the wood post, then the post sleeve skirt over the post sleeve; both should rest on the decking.

What is a standard railing?

OSHA Standard 1910.23(e)(1) defines the standard railing: A standard railing shall consist of top rail, intermediate rail, and posts, and shall have a vertical height of 42 inches nominal from upper surface of top rail to floor, platform, runway, or ramp level.

At what height is a handrail required Australia?

between 900mm-1,100mm
The standard specifies that the top of the guardrail, which is the highest vertical point of the handrail structure, must stand between 900mm-1,100mm from the top of the walkway or platform. In instances where guardrails are used on staircases, the nosing height is the reference point.

Can I use pine for deck railing?

Both pine and standard “white wood” lumber work well for deck construction. If you decide to use pine lumber for the deck top, plan on using treated lumber for the posts and framing; they are more prone to rot than the surface, which gets plenty of sun and proper ventilation.