How do you administer ferric gluconate?

How do you administer ferric gluconate?

For adult patients, injectable solutions of Ferrlecit are given in a single dose of 62.5mg/5mL (12.5mg/mL). In adult cases of iron deficiency anemia, Ferrlecit can be given as a slow-drip IV infusion of 125mg/10mL over the course of an hour. The administration rate should not exceed 12.5mg per minute.

How do you administer IV venofer?

Administer Venofer 200 mg undiluted as a slow intravenous injection over 2 to 5 minutes or as an infusion of 200 mg in a maximum of 100 mL of 0.9% NaCl over a period of 15 minutes. Administer on 5 different occasions over a 14 day period.

How long is Ferrlecit stable?

Undiluted generic SFG was stable for ≥2 days at room temperature and ≥7 days under refrigerated conditions, and generic SFG diluted in IV infusion bags containing 0.9% sodium chloride solution was stable for ≥1 day at room temperature and ≥7 days under refrigerated conditions.

What is sodium ferric gluconate complex in sucrose injection?

Ferrlecit (sodium ferric gluconate complex in sucrose) Injection is an iron replacement product used to treat iron deficiency anemia in adults and children 6 years and older with chronic kidney disease receiving hemodialysis who are receiving supplemental epoetin therapy. Ferrlecit is available in generic form.

How do you give ferric gluconate sodium?

Sodium ferric gluconate injection comes as a solution (liquid) to inject intravenously (into a vein) by a doctor or nurse in a medical office or hospital outpatient clinic. It is usually injected over approximately 10 minutes or may be mixed with another fluid and infused over 1 hour.

How is ferrous gluconate absorbed?

Absorption: Absorbed from the entire length of the GI tract, but primary absorption sites are the duodenum and proximal jejunum. Up to 10% of iron is absorbed by healthy individuals; patients with iron-deficiency anemia may absorb up to 60%.

How far apart should iron infusions be?

You may need one to three sessions of iron infusions, which are usually given about one week apart. The dosage and frequency of iron infusion will depend on which intravenous iron product your doctor prescribed and on the severity of your anemia.

How do you give an IV iron infusion?

The catheter is attached to a long tube, which is connected to an IV bag of the iron. The iron has been diluted with a saline solution. This solution is either pumped into your vein or uses gravity to slowly drip down the tube and into your vein. You may feel a slight pinch in your skin where the IV needle is inserted.

What is the cost of ferrlecit?

The cost for Ferrlecit intravenous solution (12.5 mg/mL) is around $341 for a supply of 50 milliliters, depending on the pharmacy you visit. Prices are for cash paying customers only and are not valid with insurance plans. A generic version of Ferrlecit is available, see sodium ferric gluconate complex prices.

How often is INFeD given?

Individual doses of 2 mL or less may be given on a daily basis until the calculated total amount required has been reached. INFeD is given undiluted at a slow gradual rate not to exceed 50 mg (1 mL) per minute.

What is ferrous gluconate 300 mg used for?

Ferrous gluconate is used to treat or prevent iron deficiency anemia (a lack of red blood cells caused by having too little iron in the body).

How do you administer ferric Carboxymaltose?

It is usually given as 2 doses, at least 7 days apart. It is usually given slowly over several minutes. It can also be mixed in a saline solution and given by infusion into a vein over at least 15 minutes. The dosage is based on your medical condition, weight, and response to treatment.

Is there a generic version of sodium ferric gluconate?

Both the branded product (Ferrlecit, branded SFG) and a new generic version of sodium ferric gluconate in complex (Nulecit; generic SFG) are provided in 5 mL vials. SFG may be administered by slow intravenous (IV) injection of the undiluted product or by 1 h IV infusion after dilution in 100 mL 0.9% sodium chloride.

How long is the stability of sodium ferric gluconate?

Undiluted generic SFG was stable for ≥2 days at room temperature and ≥7 days under refrigerated conditions, and generic SFG diluted in IV infusion bags containing 0.9% sodium chloride solution was stable fo … Short-term stability of a new generic sodium ferric gluconate in complex with sucrose Curr Med Res Opin.

What are the ingredients in Ferrlecit®?

Each ampule of 5 mL of Ferrlecit®for intravenous injection contains 62.5 mg (12.5 mg/mL) of elemental iron as the sodium salt of a ferric ion carbohydrate complex in an alkaline aqueous solution with approximately 20% sucrose w/v (195 mg/mL) in water for injection, pH 7.7 – 9.7. Each mL contains 9 mg of benzyl alcohol as an inactive ingredient.

What is the molecular weight of ferferrlecit?

Ferrlecit®(sodium ferric gluconate complex in sucrose injection) is a stable macromolecular complex with an apparent molecular weight on gel chromatography of 289,000 – 440,000 daltons. The macromolecular complex is negatively charged at alkaline pH and is present in solution with sodium cations.