Why is my SRS light on in my 2002 Honda Civic?
Why is my SRS light on in my 2002 Honda Civic?
This warning light will kick on when the computer does its system check and finds a fault somewhere in the SRS system. This light indicates that a fault has been detected and the airbags may not deploy or deploy properly in an accident. The causes could be something simple to complete failure of the airbag system.
Why is my seatbelt not clicking?
Step 1: Inspect the Seat Belt If the seat belt buckle won’t release easily or if the buckle won’t latch properly, it is better to check the seat belt tongue or the ‘male’ connector. Simply extend the seatbelt to the full length and check to see if there is anything stuck to the belt.
Where is the seatbelt sensor located?
Automobiles have a seat belt sensor located in the seat belt buckle of both the driver’s seat and front passenger seat.
Can seat belt pretensioners be reset?
The seat belt pretensioner can be reset to factory settings and replaced into the vehicle. Unlike most other seat belt repair shops, this company can repair single-stage, dual-stage, and even triple-stage seat belt pretensioners!
How do you reset the SRS light?
Turn Your Ignition on and Off. First, turn the ignition switch on. Next, wait for the airbag light to turn on – it normally stays lit for seven seconds before shutting itself off. Then, immediately turn off the ignition switch, and wait three seconds. Repeat the initial steps once or twice before starting the engine.
Why is my Honda Civic airbag light on?
If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.
How do I get my seatbelt unstuck?
How to Reset a Stuck Seatbelt
- Pull on the seatbelt to try and release it from its auto-lock function.
- Pry off the plastic covers that hold the seatbelt mechanism with a screwdriver or needle nose pliers.
- Pull the seatbelt out completely.
- Untangle the seatbelt if there are any jams in it.
