How do I clean the drum on my Oki printer?
How do I clean the drum on my Oki printer?
Answer
- Press ON LINE to set the printer off-line.
- Lower the manual feed tray.
- Press < / Recover and > / Reset buttons simultaneously and hold for 2 seconds.
- CLEANING MANUAL LETTER REQUEST or CLEANING MANUAL A4 REQUEST displays.
- Insert a clean sheet of letter or A4 paper in the Manual Feed Tray.
How to change oki drum?
Press [Device Settings] > [Admin Setup] > [User Install] > [Drum Near Life Timing] on the touch panel to change the setting. Available values are from 500 to 3,000 (in 500 increments).
How do you reset the image drum on a OKI printer?
ANSWER
- Start the Status Monitor for the printer.
- Click on Printer Setup tab – Printer Menu button – Maintenance 1 tab.
- Click the [Reset] button next to Drum Counter, then click on the [OK] button to reset the drum counter.
What is image drum unit?
An image drum is the unit that copies the text and images from the computer and then transfers them to the paper, along with the toner. For both of these errors, your computer and printer will let you know that whether you need a new toner cartridge or if it’s the image drum unit that needs to be replaced.
When should you replace a picture drum?
As a general rule, you should always replace your drum unit after using three to four toner cartridges just to be safe. Page yields are also calculated, with only 5% of the page being filled as an entire page. Depending on your usage, you may need to change your drum unit faster than before.
How do I check drum life on Oki printer?
You can set when to display the “Image Drum Near Life” message. Press [Device Settings] > [Admin Setup] > [User Install] > [Drum Near Life Timing] on the touch panel to change the setting. Available values are from 500 to 3,000 (in 500 increments).
What happens if you don’t replace a printer drum?
A degraded drum unit can cause streaks, smudges, and blank spots on your printed page even if you just inserted a new printer toner. While a broken drum unit won’t break your printer, it will just fail to stop printing at a certain point.
