How to rewire a trailer in 8 Simple Steps?
How to rewire a trailer in 8 Simple Steps?
Rewiring a Trailer in 8 Simple Steps 1 Sketch a trailer wiring diagram 2 Remove the old trailer lights and wiring 3 Lay out the new wiring 4 Mount the ground wire 5 Install the marker lights 6 Clip the wires onto the frame 7 Install the taillights 8 Test the trailer lights More
Where do the wires go on a trailer hitch?
The yellow and brown wires should be routed to the driver side, and the green and brown wires should go to the passenger side. The white wire will remain near the trailer tongue. Make sure you maintain an equal length of wire on each side of the trailer, and leave plenty of extra wire at the front for plugging into your vehicle.
What is a trailer wiring connector?
While some vehicles may not be equipped with a standard trailer wiring connector, they may have a special socket specifically intended for installing wiring, provided by the vehicle manufacturer. A custom wiring connector uses a single plug to plug into this factory socket and provide a standard trailer wiring connector.
How do you wire a trailer to a frame?
Route the new trailer wiring through the frame to the back of the trailer. Refer to the diagram you previously sketched as a guide. The yellow and brown wires should be routed to the driver side, and the green and brown wires should go to the passenger side. The white wire will remain near the trailer tongue.
What is a custom wiring connector for a trailer?
A custom wiring connector uses a single plug to plug into this factory socket and provide a standard trailer wiring connector. Another type of custom wiring is original-equipment (OE) wiring or USCAR wiring. Select vehicles come with a standardized USCAR socket that provides a connection point for a CURT OE wiring harness.
How do you wire a tail light to a trailer?
With each tail light in its proper position, trim the trailer wiring and strip the ends. Insert the wires into their appropriate connection points – yellow and brown for driver side, and green and brown for passenger side. With the wires securely connected bolt the tail lights onto the trailer frame.
