Why is my Maytag washer not draining or spinning?
Why is my Maytag washer not draining or spinning?
A top load Maytag washer not draining may have a defective lid switch assembly. On top-loading washers, draining and spinning will only occur if the lid is properly closed and activates the switch. Try depressing the lid switch with your finger to see if the machine drains and spins.
How do you reset a Maytag Neptune washing machine?
Turn off and unplug the washer. Wait 30 seconds. Reconnect it and press the “Power” button. This resets the unit.
How do you put a Maytag Neptune washer in diagnostic mode?
I checked the diagnostic code using the following procedure:
- Plug the washer in for power.
- Put the washer into “Service Mode” by holding the “Delicates” and “Heavy soil” keys simultaneously for 3 or more seconds.
- Pushed “Presoak” to put it in diagnostic code mode.
Why is my Maytag washer not draining?
Drain Hose Is Obstructed An obstructed drain hose is one of the most common reasons a Maytag washer won’t drain. Both kinks and blockages can obstruct the hose, preventing proper draining. A kinked hose can be gently straightened to restore function.
How do you reset a Maytag front load washer?
- Unplug the washer for 1 minute from the electrical outlet.
- Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
- The motor has now been reset and is ready for you to start a cycle.
Where is the drain on a Maytag Neptune washer?
The drain pump is located in the back of the washer. First unplug the washer. Then remove the two screws holding on the back panel. Slide the panel up, and then pull out to remove the panel.
Why is my Maytag washing machine not spinning?
Here’s What to Do Check the Lid Switch Assembly. The lid switch assembly stops the washer from spinning when the lid is not closed properly. Inspect the Drive Belt. Inspect the Motor Coupling. Test the Door Latch. Check the Motor Control Board. Check the Clutch. Check the Drive Pulley. Inspect the Rotor Assembly. Check the Stator Assembly. Check the Drive Motor.
Why is my Maytag dishwasher not cleaning?
The detergent could be the cause of the dishwasher not cleaning your dishes. First make sure you are using a high quality detergent, and if you are using gel or tablets, consider switching to a powdered detergent as it dissolves faster.
How do you clean a Maytag Neptune washer?
Use high-efficiency detergent in your Neptune washing machine to keep your washer fresh-smelling and free of buildup. Turn off the washing machine, and remove any laundry from inside of it. Examine the gray-colored seal located inside the open washing machine door.
How do you drain a Maytag Neptune washer?
Unscrew the clamp holding the hose that leads from the washer tub to the pump. Pull off the hose and direct it into a 2-gallon or larger bucket to catch water that hasn’t drained. Once all the water has drained out, remove the second hose in the same way.
